Repair of aeronautical structures by composite patch bonding has shown its effectiveness in several studies during the last few decades. This repair technique leads to a retardation in the propagation of repaired cracks via load bridging across the patch throughout the adhesive layer, interfacing it with the repaired structure. The purpose of this study is to analyze the behavior of patch-repaired cracks present in thin plates made of aluminum alloy 7075-T6 and subjected to a single tensile overload. The sequence of application of overload on the fatigue behavior was also studied. Fatigue tests were conducted on Al 7075-T6 notched specimens where crack growth and number of cycles to failure were monitored for different patching/overload scenarios. A detailed fractographic study was performed on failed specimens to analyze the micromechanical behavior of the crack growth related to each scenario. The obtained results showed that the application of the overload before bonding the patch leads to an almost infinite fatigue life of the repaired plates.
1
23 August 2025 in Journal of Failure Analysis and Prevention
The bonded composite repair technique has been widely used to extend the life of cracked structures, such as aircraft and wind turbine structures. After repair, the growth of the crack is significantly slowed until the patch begins to lose its effectiveness. To maintain a low rate of crack growth, the patch repair needs to be replaced once a critical level of adhesion damage (separation) is reached. The objective of this research is to determine the cohesive zone model (CZM) parameters for simulating mode I damage initiation and propagation in different thicknesses of Araldite®2015 structural adhesive. First, mode I load–displacement curves were obtained experimentally using double cantilever beam (DCB) tests. Next, the corresponding fracture toughnesses (GIc) were calculated using the compliance-based beam method (CBBM), which does not require measuring the crack length during testing. Finally, finite element analysis (FEA) was used to predict the progression of adhesion damage using three different softening laws: triangular, trapezoidal, and exponential. The study found that mode I fracture energy is the same for adhesive thickness between 0.20 and 0.30 mm, but then increases by 27% when the adhesive thickness becomes 0.35 mm. Numerically, the results showed good agreement across all softening shapes, with the trapezoidal law being considered the most computationally efficient.
1 April 2019 in International Journal of Engineering Research in Africa
A fatigue damage accumulation model for composite materials is proposed. There is unanimity on the complex nature of the mechanisms of damage inherent to these types of materials. This led to proposals for nonlinear models, but relatively expensive in experimental requirements and determination of parameters. Thus, the proposed model is simple and does not require parameters apart the ultimate strength and the fatigue curve. A program is developed to allow the follow-up of the damage evolution during the cycles of loading. The proposed model is applied to E-Glass/Epoxy [0°/90°] under two blocks loading. Prediction results are relatively good and fit well with the experimental results compared to similar models.