The aim of this study was to investigate the pozzolanic effect (PE) and filler effect (FE) of rice husk ash (RHA) on the mechanical properties and microstructure of brick aggregate concrete (BAC). For this, concrete cylinders (100 mm × 200 mm) were prepared with 0-25% RHA with water-to-binder ratios of 0.50 at a constant mix-ratio of 1:1.5:3 and cured in water. Test results revealed that the mean particle size of RHA decreases with increasing grinding time. The compressive strength ( f c ' ) of BAC due to filler effect are 58.56-94.62% less compared to the pozzolanic effect of RHA for the 10%-25% replacement of cement. Meanwhile, the 15% RHA showed the maximum f c ' of BAC due to pozzolanic effect of RHA. The tensile strength ( f s p ) and flexural strength ( f r ) of BAC due to pozzolanic effect are 60%-150% and 25%-150% higher than that of filler effect of RHA for the 10%-25% replacement of cement respectively. The modulus of elasticity ( E c ) and Poisson's ratio ( ν ) of BAC due to pozzolanic effect are 2%-29% and 27%-43% greater than that of filler effect of RHA for the 10%-25% replacement of cement respectively. BAC with 10-20% RHA shows a dense and homogeneous microstructure. Therefore, inclusion of RHA as a partial replacement of cement possesses a significant pozzolanic effect than the filler effect on the mechanical properties and microstructure of BAC.
10 April 2020 in Construction and Building Materials
The objective of this research was to determine the mechanical properties, including among others compressive strength , tensile strength , flexural strength , modulus of elasticity , and Poisson’s ratio of a brick aggregate concrete (BAC) containing rice husk ash (RHA) as a partial replacement of cement. Concrete cylinders with 100-mm diameter and 200-mm height were cast using 0–25% RHA as a partial replacement of cement with water-to-binder ratios of 0.45, 0.50, and 0.55, with a mix ratio of 1:1.5:3, and cured in water at room temperature. The experimental results indicated that and increased gradually with the increasing RHA up to 15%. However, the maximum values of these were observed with 10% RHA. By contrast, of BAC containing up to 25% RHA was found lower than that of control concrete. and of BAC with RHA were higher than those of control concrete. It was observed that mechanical properties of BAC were influenced significantly due to the inclusion of 15% RHA as a partial replacement of cement with a water-to-binder ratio of 0.50.