Animal research undoubtedly provides scientists with virtually unlimited data but inflicts pain and suffering on animals. Currently, legislators and scientists alike are promoting alternative in vitro approaches allowing for an accurate evaluation of processes occurring in the body without animal sacrifice. Historically, one of the most infamous animal tests is the Draize test, mainly performed on rabbits. Even though this test was considered the gold standard for around 50 years, the Draize test fails to mimic human response mainly due to human and rabbit eye physiological differences. Therefore, many alternative assays were developed to evaluate ocular toxicity and drug effectiveness accurately. Here we review recent achievements in tissue engineering of in vitro 2D, 2.5D, 3D, organoid and organ-on-chip ocular models, as well as in vivo and ex vivo models in terms of their advantages and limitations.

Water can be used as an ecological lubricant base if it is possible to select additives which can beneficially modify its tribological and corrosion properties. Additionally, those additives should not be harmful to human health and the natural environment. These conditions limit or even eliminate the possibility for the application of the additives used in traditional oil bases as they are insoluble in water and often toxic. Alkyl polyglucosides (APGs) have been suggested as additives improving lubricating properties of water. They are biodegradable and do not have to be recycled. They exhibit surface activity. They produce micelles at low concentration and lyotropic liquid crystals at high concentration. Two types of alkyl polyglucosides differing in alkyl chain lengths and degrees of polymerization were used in this investigation. Tribological tests were carried out using a ball‐on‐disc T‐11 tester. The balls were made of steel, whereas the discs were made of steel, aluminium oxide, zirconium oxide, polyamide and poly(methyl methacrylate). The description of the device and the methods has been given in the literature (Szczerek and Tuszyński in TriboTest 8:273–284, 2002). The addition of APGs improves the lubricating properties of water. The relative decrease in motion resistance and wear depends both on the type of friction couple and on the kind of alkyl polyglucoside used. The tribological test results obtained were correlated with the activity of APGs measured as wettability of friction couples by their solutions.

Psoriasis is a chronic disorder that causes a rash with itchy, scaly patches. It affects nearly 2–5% of the worldwide population and has a negative effect on patient quality of life. A variety of therapeutic approaches, e.g., glucocorticoid topical therapy, have shown limited efficacy with systemic adverse reactions. Therefore, novel therapeutic agents and physicochemical formulations are in constant need and should be obtained and tested in terms of effectiveness and minimization of side effects. For that reason, the aim of our study was to design and obtain various hybrid systems, nanoemulgel–macroemulsion and nanoemulgel–oleogel (bigel), as vehicles for ursolic acid (UA) and to verify their potential as topical formulations used in psoriasis treatment. Obtained topical formulations were characterized by conducting morphological, rheological, texture, and stability analysis. To determine the safety and effectiveness of the prepared ursolic acid carriers, in vitro studies on human keratinocyte cell-like HaCaT cells were performed with cytotoxicity analysis for individual components and each formulation. Moreover, a kinetic study of ursolic acid release from the obtained systems was conducted. All of the studied UA-loaded systems were well tolerated by keratinocyte cells and had suitable pH values and stability over time. The obtained formulations exhibit an apparent viscosity, ensuring the appropriate time of contact with the skin, ease of spreading, soft consistency, and adherence to the skin, which was confirmed by texture tests. The release of ursolic acid from each of the formulations is followed by a slow, controlled release according to the Korsmeyer–Peppas and Higuchi models. The elaborated systems could be considered suitable vehicles to deliver triterpene to psoriatic skin.

Liquid soaps are the basic cosmetics used to clean the skin of the hands. Frequent hand washing prevents viral contamination but may damage the skin’s hydro-lipid layer, leading to various types of irritation. Therefore, four liquid soap formulas were developed with three amphoteric surfactants: Cocamidopropyl Betaine (LS II), CocamidopropylHydroxysultaine (LS III), and newly synthesized Evening PrimroseaamidopropylSulfobetaine (LS IV). We evaluated the skin irritating potential (zein number, bovine albumin test) and cytotoxicity (AlamarBlue™, Cell viability, and Cell cycle assays) on HaCaT cell line. We observed lower values of the zein number and bovine albumin tests after adding soaps with surfactants (the highest differences in LS IV) compared to the base soap (LS I). However, LS I and LS II did not differ in cytotoxic assays. Therefore, adding LS III and LS IV seems potentially more dangerous to the cells. However, it should be noted that cells were continuously exposed to liquid soaps for more than 24 h, so its cytotoxic effects after dermal use in humans may be unnoticeable. Concluding, results suggest that the newly synthesized LS IV should improve the safety of liquid hand washing soaps.

The purpose of the study was to applicate new synthesized zwitterionic surfactants as hair shampoo components. Hair shampoos formulated for the study contained newly synthesized sulfobetaines at a concentration of 2%. The above additives were evaluated to determine their effect on shampoo dynamic viscosity, texture, yield stress, foaming properties and surface tension of aqueous shampoo solutions. The viscosity of the sulfobetaine-enriched hair shampoos ranged between 6,000 and 21,000 mPa·s, which ensures the required application properties of the formulated products. The yield stress in three prototypical shampoos was equal to approximately 10 Pa, which represents the minimum value that should characterize cosmetics of this type. The sulfobetaines added to the formulations were not found to significantly affect the parameters of hardness and adhesive force. All the formulations under study, except for the shampoo containing N-dodecyl-N-piperidinium-1-propanesulfonate, exhibited good foaming properties. The incorporation of sulfobetaines into hair shampoos contributes to an effective decrease in the surface tension of their aqueous solutions, which may indicate beneficial washing properties. The use of the proposed sulfobetaines in hair shampoos favorably modifies their physicochemical and functional properties. The findings of the study can provide useful insights for the formulation of hair shampoos containing zwitterionic surfactants.

Emollients are valued ingredients of many cosmetic products and medical devices used to support the treatment and prevention of many skin diseases. Despite the fact that they are one of the oldest cosmetic ingredients, raw materials as well as new recipe solutions are constantly being sought, the main goal of which is to obtain products with the most favorable physicochemical properties while improving the hydration of the stratum corneum and softening and smoothing the skin. It should be noted that there are few scientific articles on the effect of emollients on the physicochemical and usable properties of emollient preparations of the body-oils type. The obtained formulations were subjected to physicochemical tests (dynamic viscosity, surface tension, contact angle, and color evaluation), and the degree of skin hydration and lubrication after application of the developed cosmetic oils was evaluated. Cosmetic oils based on natural emollients were characterized by weaker spreading abilities, which was confirmed by their higher viscosity, surface tension, and contact-angle results relative to those obtained for cosmetic oils based on synthetic emollients. In addition, it was found that the use of both groups of cosmetic oils based on natural and synthetic emollients leads to an increase in the degree of hydration of the skin and an increase in its oiliness. However, a higher increase in the degree of hydration and a lower decrease in the level of skin lubrication are observed after the application of body oils based on natural emollients.