Xuquan Hu

Xuquan Hu


Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
20 September 2021 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
WLWei Liu
Wei Liu
XHXuquan Hu
Xuquan Hu
XLXian Liao
Xian Liao
LLLonghuan Liu
Longhuan Liu
ZFZhihong Fu
Zhihong Fu
This article presents a novel design of a bipolar current-pulsed power supply (BCPPS) for shallow electromagnetic detection. Problems of acquiring current pulses with low oscillation and low energy cost are analyzed in detail and relevant solutions are given. An improved topology based on a constant-voltage clamping circuit is proposed to satisfy the demands of supplying the highly inductive load. The relationship between the main steady-state parameters of the proposed BCPPS is provided and the shape of current pulses can be adjusted flexibly by changing the duty cycles of the switching signals in the topology. A feedforward control strategy to realize constant-current transmitting is proposed and the digital controller is designed. Compared with different existing current-pulsed sources, the topology in this article is characterized by high repeat frequency, low energy cost, and low switching interference. A laboratory prototype with a maximum peak current of 50 A and repeat frequency of 500 Hz is built to verify the effectiveness of the proposed topology.

14 September 2023 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Open access
XLXian Liao
Xian Liao
ZXZhengyu Xu
Zhengyu Xu
WLWei Liu
Wei Liu
XHXuquan Hu
Xuquan Hu
JZJie Zhou
Jie Zhou
ZFZhihong Fu
Zhihong Fu
In transient electromagnetic (TEM) inverter circuits, a damping resistor is typically connected in parallel to the transmitting coil to prevent overshoot during the turn-off period of the pulse current. This configuration results in an exponential decay waveform for the pulse current, which prolongs the turn-off time and increases the nonlinear error. This article analyzes the impact of the parasitic capacitance on the value of the damping resistor and the end-period waveform of the pulse current base on the inverter circuits, and proposes an optimized control method to reduce both the turn-off time and the nonlinear error of the pulse current. The method is validated through the construction of an experimental circuit. According to the experimental data, this optimization method reduces the turn-off time by 23.8% and the nonlinear error by 5.5%. In the unexploded ordnance (UXO) detection experiment, the optimization method’s detection results exhibit higher resolution.

12 May 2022 in Lithosphere
Verified
Journal Article
Open access
PDF file
XLXinglin Lu
Xinglin Lu
XHXuquan Hu
Xuquan Hu
ZXZhengyu Xu
Zhengyu Xu
XLXian Liao
Xian Liao
LLLonghuan Liu
Longhuan Liu
ZFZhihong Fu
Zhihong Fu
The water-rich giant karst cave is the risk source of tunnel construction in the karst area. To reduce the risk of tunnel construction, it is necessary to accurately explore the spatial distribution range of the karst cave in the direction of advance and both sides of the tunnel. Reflection seismic and transient electromagnetic (TEM) are the primary geophysical tools for tunnel advanced prediction; they have strengths and weaknesses. The tunnel seismic can only describe the boundary interface between cave bodies and surrounding rock in the direction of advance. Although the TEM method can detect the spatial distribution range of cave bodies, the inversion results depend on the initial resistivity model. The single method is insufficient to describe the spatial distribution of cave bodies. To overcome the shortcoming of a single method, we developed tunnel seismic and TEM joint detection of karst cavern and established a complete data processing flow. The tunnel seismic migration profiles can describe the interface between the karst cave and surrounding rock in the direction of advance. We put forward a reasonable initial model: (1) the layer’s thicknesses are determined by the impedance interface from the tunnel migration data; (2) the initial resistivity values are determined from the pilot hole and prior geological data. Comparison of the inversion results of different initial models of tunnel face horizontal line data proves that the proposed initial model method can reduce multisolution, save calculation time, and improve inversion accuracy. The multidirectional TEM inversion profiles can describe the spatial distribution of the giant cave. Combined with the results of tunnel seismic and TEM, the interpretation errors can be reduced and the extension of the karst cave can be delineated. Later excavation results also verify the accuracy of the prediction results.

6 April 2021 in IET Power Electronics
Verified
Journal Article
Open access
PDF file
WLWei Liu
Wei Liu
XHXuquan Hu
Xuquan Hu
XLXian Liao
Xian Liao
LLLonghuan Liu
Longhuan Liu
ZFZhihong Fu
Zhihong Fu
A high‐current pulsed source with high charging efficiency, high stability and low current ripple is proposed for airborne transient electromagnetic method application. The high voltage capacitor bank is employed to provide and store energy for generating current pulses in the inductive load. An N‐channel interleaved boost module is designed to replenish the capacitor energy gap so that current pulses can be repeated in a short time. The operation principles of the proposed topology are explained and the theoretical analysis is provided. In addition, a convenient and effective control strategy to raise efficiency of the charging circuit is introduced. The concise closed‐loop control method directed at the characteristics of load variations is available for changing the steady operation and control the output current. Logic input and output modules based on field programmable gate array are designed for the controller. A laboratory prototype with the maximum peak current 400 A is built for the load coil of 2.1 mH and 150 mΩ to verify the effectiveness of the proposed topology and control method.

18 August 2025 in IEEE Transactions on Instrumentation and Measurement
Verified
Journal Article
Closed access
XHXuquan Hu
Xuquan Hu
NFNengyi Fu
Nengyi Fu
ZCZhiyin Chen
Zhiyin Chen
HTHeng-Ming Tai
Heng-Ming Tai
Elimination of primary field effect is crucial to the success in the transient electromagnetic (TEM) system. Instrument and algorithm solutions have been developed to compensate for the unwanted primary field signals during current turn-off. These solutions include bucking coil, opposing coil, and crossing-loop coil. They are mainly structural designs in the sense that the size and turns of the compensation coils are prespecified and compensation currents are fixed. This paper proposes an adjustable compensation system for the elimination or removal of primary field effects. The proposed system differs from the above structure-oriented coil designs in that the compensation currents are adjusted electronically based on the current operating conditions. Compensation also can be easily readjusted to cope with the situation that the coil frame is moved from set location. Experimental results are presented to verify the effectiveness of the proposed compensation system and to demonstrate that the system can work for the small loop configuration.

1 January 2026 in IEEE Journal of Emerging and Selected Topics in Power Electronics
Verified
Journal Article
Closed access
MLMingyu Liao
Mingyu Liao
ZFZhihong Fu
Zhihong Fu
GDGuang Deng
Guang Deng
FCFeng Cheng
Feng Cheng
ZZZhiguo Zhang
Zhiguo Zhang
WYWenjie You
Wenjie You