We propose an instantaneous frequency measurement (IFM) scheme featured with unambiguous measurement utilizing a Sagnac loop with an embedded bi-directional phase modulator and an optical filter with a linear frequency response. The frequency of the microwave signal to be measured is instantaneously estimated by calculating an amplitude comparison function (ACF) of photocurrents from the upper and lower branches of the proposed structure. Compared to previous IFM schemes, the ACF in the proposed scheme is monotonic, by which the frequency of the unknown microwave signal can be uniquely confirmed without ambiguity. Only one laser source and a phase modulator are needed, which simplifies the measurement system. In addition, the monotonous ACF can guarantee measurement accuracy in a wide range, from low frequency to high frequency. The IFM system has robustness in optical and RF power shifts. Simulation results show that frequency measurement over the range of 30 GHz with a measurement error of 0.4 GHz is achieved.
With the rapid development in sensor network technology, the complexity and diversity of application scenarios have put forward more and more new requirements for inductor–capacitor (LC) sensors, for instance, multi-parameter simultaneous monitoring. Here, the parity–time (PT) symmetry concept in quantum mechanics is applied to LC passive wireless sensing. Two or even three parameters can be monitored simultaneously by observing the frequency response of the reflection coefficient at the end of the readout circuit. In particular, for three-parameter detection, a novel detection method is studied to extract the three resonant frequencies of the system through the phase–frequency characteristics of the reflection coefficient, which has never appeared in the previous literature on PT symmetry. The changes in three resonant frequencies are in response to changes in the three parameters in the environment. We show theoretically and demonstrate experimentally that the PT-symmetric LC sensor can realize multi-parameter measurement using a series LCR circuit as the sensor and a symmetric adjustable LCR circuit as the readout circuit. Our work paves the way for applying PT symmetry in multi-parameter detection.
An effective scheme of frequency doubling up-conversion is proposed and demonstrated, which achieves the generation of high-frequency microwave signal and the compensation of chromatic dispersion-induced power fading (CDIPF). The system structure is based on a cascading of a Sagnac loop and a Mach-Zehnder modulator (MZM), where a phase modulator is used in the Sagnac loop. In the loop, only the clockwise propagating light wave is modulated by a small local oscillator signal, leaving the counter-clockwise propagating light wave unmodulated because of the velocity mismatch. The output signal is divided into two parts, one traveling into an MZM and the other entering an optical phase shifter. The intermediate frequency signal is supplied to the MZM, which is biased at its minimum point and then the carrier-suppressed double sideband is achieved. With the adjustment of the optical phase shift, the CDIPF can be compensated at any frequency. In the simulation, by comparing the frequency responses of the proposed link with and without dispersion compensation, we successfully demonstrate the performance of power fading compensation for 60- and 80-km link. Consequently, the spurious-free dynamic range is effectively improved by 13.54 dB at 22.6 GHz for 60-km link.
An all-optical image rejection (IR) mixer, based on a dual electrical port phase modulation (PM) in a Sagnac loop and a wavelength division multiplexer (WDM), is proposed. The radio frequency (RF) and the local oscillator signals are loaded onto the two electrical ports of the PM, respectively. The two down-conversion channels are obtained with the use of WDM. A pair of phase orthogonal down-converted intermediate frequency (IF) signals are obtained by properly adjusting polarization controller. Then an electrical low-frequency 90 hybrid coupler (90 HC) combines the two IF signals to double the desired IF signal and suppress the image interference IF signal. In the simulation, a 30-GHz RF signal is successfully down-converted to 1 GHz with about 57 dB IR. Compared with the IR mixer based on two parallel PMs, conversion efficiency is improved about 6 dB.