The Calloviane-Oxfordian carbonates in the northeastern Amu Darya Basin of southeastern Turkmenistan are composed of medium- to thick-bedded, mostly grainy limestones with various skeletal (bivalves, brachiopods, echinoderms, foraminifera, corals, and sponge) and non-skeletal grains (intraclasts, ooids and peloids). Two facies zones, six standard facies belts and some microfacies types were recognized, and sedimentary model “carbonate ramp-rimmed platform” was proposed and established that can be compared with the classical carbonate sedimentary models. In this model, favorable reservoirs not only developed in the intraplatform shoal of open platform, or reef and shoal on the platform margin, but also in the patch reefs, shoal and mound facies on the upper slope. The reservoir’s pore space is dominated by intergranular and intragranular pores and fissure-pore reservoirs exist with medium porosity and medium to low permeability. Sedimentary facies and diagenetic dissolution are the key controlling factors for the development of high-quality reservoirs.

Siliceous-sulphate rock coatings were observed at Zhenzhu Spring, an acid sulphate hot spring in the Tengchong volcanic field, China. These rock coatings are mainly formed of gypsum and amorphous silica. Some alum-(K), voltaite, α-quartz and muscovite were also found. Four different laminae are developed in the rock coatings: gypsum layer, tight siliceous layer, tabular siliceous layer and siliceous debris layer. The gypsum layer is located at the top of the rock coatings, while other siliceous layers appear below the gypsum layer. Geochemical modelling of the fluids was performed to identify the mechanisms responsible for the formation of gypsum and amorphous silica. The results indicated that the occurrence of gypsum is related to the acid-fog deposition and amorphous silica mainly originates from spring water. Fog deposition provided the rock coatings with abundant SO₄²⁻and Ca, and the subsequent complete evaporation of the condensed fluids produced gypsum. Seasonal climate change (especially variation in rainfall) determines the fluctuations of capillary action and dissolution. Rainfall events in the wet season led to periods of non-precipitating gypsum and promoted the capillary rise of the spring water. Slightly diluted capillary water (a small amount of rainwater) covered the rock coatings, formed a tight siliceous layer on the rock-coating surface and/or filled the pores among the gypsum crystals forming many tabular siliceous aggregates. Heavy rainfall (high dilution), however, resulted in non-precipitating amorphous silica and accelerated the gypsum dissolution, leaving tabular pores around tabular siliceous aggregates and forming a tabular siliceous layer.

Argon ion polishing and FE-SEM techniques were used to study the Micro/nano pore of the shale Gas reservoir of Da’anzhai section in eastern Sichuan basin. Six types of pores were found to have developed in the reservoir: (1) Organic matter with nm-grade pores on the surface in dispersed form with poor connectivity; (2) nm-grade intergranular pores inside berry spherical pyrite aggregation with poor connectivity; (3) nm-grade grain pores in biological debris with poor connectivity; (4) alignment nm-grade pores between layers of clay minerals with good connectivity; (5) nm–μm grade solvent hole in clay mineral layer with good connectivity; and (6) microcracks, also nm–um grade, most of which are developed in the organic matter and brittle mineral edge with good connectivity. Among them, types 4, 5, and 6 are the main reservoir spaces. With the use of the cryogenic liquid nitrogen adsorption and BET equation, the calculated pore size distribution of shale reservoir in Da’anzhai includes 10 nm–25 nm mesopores, 100 nm–150 nm large pores, which account for a greater proportion, and a few <5 nm small pores. The specific surface area of shale reservoir was positively correlated to the pore volume, confirming that the pore diameters were mainly nanoscale mesopores. Correlated analyses were conducted between the specific surface area and clay minerals, organic carbon content, and vitrinite reflectance. Results show that clay mineral content exerted the most obvious control over shale reservoirs relative to nanoscale pore development. Meanwhile, organic maturity also had a certain influence, whereas content exerted very limited control over pore development.

On the basis of petrology, in combination with analysis of the geochemical characteristics of major and trace elements, REE (rare earth elements), carbon isotopes, oxygen isotopes, strontium isotopes and fluid inclusions, the geochemical characteristics and fluid properties of the Qixia Formation dolomites of the Middle Permian Qixiain the Shuangyushi block in the NW Sichuan Basin were systematically studied. The analysis results of the samples show that the Qixia dolomites are mainly composed of medium, coarse, medium-coarse crystalline and dolomites with polymodal crystal size distribution, and cloudy centers and clear rims. They generally show dark purple cathodoluminescence (CL) colors in the centers and orange red CL colors in the rims. The Qixia dolomites are relatively highly ordered (0.79–0.95, averaging 0.90). The CaO and MgO contents show a negative correlation. They are characterized by higher Mg/Ca ratio (0.89–0.92, averaging 0.91), high Fe (94–2,991 ppm, averaging 622 ppm), high Mn (26–185 ppm, averaging 102 ppm), high Na (210–374 ppm, averaging 277 ppm) contents, low Sr (53–218 ppm, averaging 93 ppm) content and lower ∑REE (1.10–5.56 ppm, averaging 2.08 ppm) concentrations. The REE patterns of the dolomites are similar to those of the calcites (C1), and are characterized by light REE (LREE) enrichment, heavy REE (HREE) depletion (LREE/HREE = 5.38–9.58, averaging 7.10), and Eu (0.65–4.19, averaging 1.70) and Ce (0.99–9.52, averaging 2.61) positive anomalies. They have consistent δ¹³C (1.98–4.27‰ VPDB, averaging 3.01‰ VPDB) and δ¹⁸O (−9.54‰–−4.65‰ VPDB, averaging −7.09‰ VPDB) values with the coeval seawater. The salinity index Z is larger than 120, with diagenetic temperature higher than normal temperature. The average value of ⁸⁷Sr/⁸⁶Sr is positive (0.707150–0.712273, averaging 0.708669), while some samples are consistent to those of the coeval seawater. Their homogenization temperatures of fluid inclusions (96.3°C–105.0°C, averaging 101.1°C) exceed 100°C, which is equivalent to the buried paleogeothermal temperature, and their salinity (12.3%–14.3%, averaging 13.5%) is 3–5 times that of normal seawater. Based on the regional geological setting and previous research achievements, the dolomitized fluids in the Qixia Formation are probably derived from seawater or marine fluids sealed in pores under shallow-burial environment. The dolomites experienced late alternation by deep high-salinity hydrothermal fluids, and were formed before the Middle-Late Triassic Period.