NiTi shape memory alloy films were prepared by magnetron sputtering using a compound NiTi target and varying deposition parameters, such as power density, pressure, and deposition time. To promote crystallization, the films were heat treated at a temperature of 400 °C for 1 h. For the characterization, scanning electron microscopy, energy dispersive X-ray spectroscopy, atomic force microscopy, synchrotron X-ray diffraction, and nanoindentation techniques were used on both as-deposited and heat-treated films. Apart from the morphology and hardness of the as-deposited films that depend on the deposition pressure, the power applied to the target and the deposition pressure did not seem to significantly influence the characteristics of the NiTi films studied. After heat treatment, austenitic (B2) crystalline superelastic films with exceptionally high nickel content (~60 at.%) and vein-line cross-section morphology were produced. The crystallization of the films resulted in an increase in hardness, Young’s modulus, and elastic recovery.
Titanium alloys such as Ti-6Al-4V are widely used in biomedical implants due to their excellent mechanical properties and biocompatibility, but their bioinert nature limits osseointegration and antibacterial performance. This study proposes a multifunctional surface coating system integrating a thermally oxidized TiO2 interlayer with a hydroxyapatite (HAp) top layer synthesized via a green route using Hylocereus undatus extract. The HAp was deposited by electrophoretic deposition (EPD), enabling continuous coverage and strong adhesion to the pre-treated Ti-6Al-4V substrate. Structural, morphological, chemical, and electrical characterizations were performed using XRD, SEM, EDS, Raman spectroscopy, and impedance spectroscopy. Bioactivity was assessed through apatite formation in simulated body fluid (SBF), while antibacterial properties were evaluated against Staphylococcus aureus. The results demonstrated successful formation of crystalline TiO2 (rutile phase) and calcium-rich HAp with good surface coverage. The HAp-coated surfaces exhibited significantly enhanced bioactivity and strong antibacterial performance, likely due to the combined effects of surface roughness and the bioactive compounds present in the plant extract. This study highlights the potential of eco-friendly, bio-inspired surface engineering to improve the biological performance of titanium-based implants.