The research on the formation factors of rock burst is one of the main research directions of rock mechanics in recent years, which is helpful to solve the problem of rock burst accidents. So, in this study, the calculation method of energy released during rock burst is first obtained by using different medium models, and then, the formation factors of rock bursts are obtained by comparing the calculation energy with the actual accident energy. The method of energy calculation utilizes the difference between elastoplastic and pure elastic models to innovatively quantify the specific values of energy released before and after the occurrence of the rock burst. It is considered that the stress and plastic zone state before the occurrence of rock burst have an important influence on the occurrence of the accident and are one of the formation factors, while the deviatoric stress field and butterfly-shaped plastic zone create conditions for greater energy release. In addition, the trigger stress constitutes another formation factor. The plastic zone state before rock failure is verified by the experimental test; the location distribution shape of acoustic emission (AE) events during the later stage of compression failure is approximately the same as theoretical result. The results also preliminarily indicated the fractal characteristics of acoustic emission events distribution before sample failure. The study obtained the formative factors of rock burst accident, which provides a new ideas and references for the research on the formation of rock bursts.
The localization results of acoustic emission (AE) events can reflect the location and pattern of burst-prone rock failures. However, event localization heavily depends on the quality of the original waveform of the sensor. Therefore, this study analyzed the AE waveform of a rock sample under compression to evaluate its failure localization and quality. From the research results, it could be seen that the initial failure was relatively calm, with clear take-off points, which can be better used for accurate AE event positioning. However, the later failure was severe, causing the take-off points of most sensors to be very unclear, and positioning methods that rely on take-off points cannot be used for positioning, let alone simply using the positioning results of the built-in software. This research result reminds researchers who use AE signals for event localization to first examine the quality and status of the original waveform, providing a basis for obtaining accurate localization results, in order to further accurately study the subsequent failure patterns. The above facts indicate that the initial failure is small and scattered, while the later failure is large and concentrated, with certain fractal characteristics.
The location and characteristics of the vibration event in the heading face of a coal mine are of great significance for the monitoring and early warning of rock burst. The aim of the study is to reveal the occurrence location and propagation characteristics of macro vibration events in a heading face of coal mine. After statistics and analysis, the occurrence location of the events is mostly around the head of heading face revealed by amplitude sequencing and arrival time sequencing. As the vibration event propagates to the rear sensors, the amplitude presents exponential attenuation, which is the same as the ideal state; however, the main frequency does not appear with linear attenuation, which is obviously different from the ideal state. The reason for the inconsistency of the main frequency is probably related to the complex underground environment. The results of the main frequency results in this study are completely opposite to the previous study, indicating that the inconsistency of the main frequency should be regarded carefully when using as an early warning index.