Accurate detection of implant loosening is crucial for early intervention in total hip replacements, but current imaging methods lack sensitivity and specificity. Vibration methods, already successful in dentistry, represent a promising approach. In order to detect loosening of the total hip replacement, excitation and measurement should be performed intracorporeally to minimize the influence of soft tissue on damping of the signals. However, only implants with a single sensor intracorporeally integrated into the implant for detecting vibrations have been presented in the literature. Considering different mode shapes, the sensor’s position on the implant is assumed to influence the signals. In the work at hand, the influence of the position of the sensor on the recording of the vibrations on the implant was investigated. For this purpose, a simplified test setup was created with a titanium rod implanted in a cylinder of artificial cancellous bone. Mechanical stimulation via an exciter attached to the rod was recorded by three accelerometers at varying positions along the titanium rod. Three states of peri-implant loosening within the bone stock were simulated by extracting the bone material around the titanium rod, and different markers were analyzed to distinguish between these states of loosening. In addition, a modal analysis was performed using the finite element method to analyze the mode shapes. Distinct differences in the signals recorded by the acceleration sensors within defects highlight the influence of sensor position on mode detection and natural frequencies. Thus, using multiple sensors could be advantageous in accurately detecting all modes and determining the implant loosening state more precisely.

When designing a system at the Electronic System Level (ESL), designers are confronted with a very large number of design decisions, each affecting the characteristics of the resulting system. Simultaneously, the demands for the system’s performance, reliability, and energy consumption have increased drastically. Design Space Exploration (DSE) aims to facilitate this complex task by automating the system synthesis and traversing the design space autonomously. Previous studies on DSE have mainly considered fixed architectures with a fixed set of hardware components only. In the paper at hand, we overcome this limitation to allow for a higher degree of freedom in the design of a multiprocessor system. Instead of a fixed architecture as input, we are using a resource library containing resource types whose instances can then be arbitrarily placed and connected. More specifically, we enable the exploration of the types, the number, and the positions of required processing-type instances in a grid-based topology template in addition to deciding on the remaining system synthesis tasks, namely, resource allocation, task binding, routing, and scheduling. We provide an extensible framework, based on Answer Set Programming (ASP) modulo Theories (ASPmT), for generating system architectures fulfilling predefined constraints. Our studies show that this higher degree of freedom, originating from fewer restrictions regarding the architecture, leads to an increased complexity of the problem. In extensive experiments, we show scalability trends for a set of parameters, demonstrating the capabilities and limits of our approach.

The TomoSense experiment comprises campaign and research activities in support of future Synthetic Aperture Radar (SAR) mission concepts at P-, L-, and C-band by the European Space Agency (ESA). The research is intended to provide a quantitative basis for the evaluation of single-pass interferometry over temperate forests at L- and C-band and investigate potential synergies between C-band convoy mission concepts and future P- and L-band missions. SAR acquisitions include P- L-, and C-band data acquired at the Eifel National Park in Germany by flying approximately 25 trajectories to provide tomographic imaging capabilities. Land C-band data were acquired by simultaneously flying two aircraft to gather bistatic data with varying interferometric baselines. Field activities include forest census (dbh, tree height and species) at 80 plots and Terrestrial Laser Scanning (TLS). The dataset is complemented by small-footprint Airborne Lidar Scanning (ALS) and derived products. Preliminary results are here shown relative to polarimetric tomography at P-band and L-band imaging.