Bo Yang

Bo Yang


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 February 2023 in Micromachines
Verified
Journal Article
Open access
PDF file
WYwenkai yue
wenkai yue
RLRuixuan Liu
Ruixuan Liu
PLpeixian li
peixian li
XZXiaowei Zhou
Xiaowei Zhou
YLY Liu
Y Liu
XWXiaowei Wang
Xiaowei Wang
In this paper, the X-ray diffraction full width at half the maximum (XRD FWHM) of a 3.5 µm-thick hydride vapor phase epitaxy-aluminum nitride (HVPE-AlN) (002) face after high-temperature annealing was reduced to 129 arcsec. The tensile strain in the HVPE-AlN samples gradually released with the increasing annealing temperature. When the annealing temperature exceeded 1700 °C, an aluminum oxynitride (AlON) region was generated at the contact interface between HVPE-AlN and sapphire, and the AlON structure was observed to conform to the characteristics of Al5O6N by high-resolution transmission electron microscopy (HRTEM). A 265 nm light-emitting diode (LED) based on an HVPE-AlN template annealed at 1700 °C achieved a light output power (LOP) of 4.48 mW at 50 mA, which was approximately 57% greater than that of the original sample.

6 June 2024 in Micromachines
Verified
Journal Article
Open access
PDF file
ZZZhuang Zhao
Zhuang Zhao
YLY Liu
Y Liu
PLpeixian li
peixian li
XZXiaowei Zhou
Xiaowei Zhou
BYBo Yang
Bo Yang
YXYingru Xiang
Yingru Xiang
In this study, we propose a polarized electron blocking layer (EBL) structure using AlxGa1−xN/AlxGa1−xN to enhance the internal quantum efficiency (IQE) of AlGaN-based ultraviolet light-emitting diodes (UV LEDs). Our findings indicate that this polarized EBL structure significantly improves IQE compared to conventional EBLs. Additionally, we introduce an electric-field reservoir (EFR) optimization method to maximize IQE. Specifically, optimizing the polarized EBL structure of AlxGa1−xN/AlxGa1−xN enhances the hole drift rate, resulting in an IQE improvement of 19% and an optical output power increase of 186 mW at a current of 210 mA.

29 April 2024 in Micromachines
Verified
Journal Article
Open access
PDF file
YLY Liu
Y Liu
XZXiaowei Zhou
Xiaowei Zhou
PLpeixian li
peixian li
BYBo Yang
Bo Yang
ZZZhuang Zhao
Zhuang Zhao
This work investigated the impact of periodic thickness and doping region on the doping efficiency of the P-type AlGaN superlattice. In this paper, the band structure of the simulated superlattice was analyzed. The superlattice structure of Al0.1Ga0.3N/Al0.4Ga0.6N, and the AlGaN buffer on the sapphire substrate, achieved a resistivity of ~3.3 Ω·cm. The results indicate that barrier doping and low periodic thickness offer significant advantages in introducing a reduction of the resistivity of P-type AlGaN superlattice structures.

26 November 2024 in Micromachines
Verified
Journal Article
Open access
PDF file
YLY Liu
Y Liu
XYXue Yang
Xue Yang
XZXiaowei Zhou
Xiaowei Zhou
PLpeixian li
peixian li
BYBo Yang
Bo Yang
JBJunchun Bai
Junchun Bai
A graded composition superlattice structure is proposed by combining simulation with experimentation. The structural factors affecting graded symmetric superlattices and graded asymmetric superlattices and their action modes are simulated and analyzed. A Mg-doped graded symmetric superlattice structure with high Al content, excellent structural quality, good surface morphology and excellent electrical properties was grown by MOCVD equipment. The AlxGa1−xN superlattice with Al composition of 0.7 in the barrier exhibits a hole concentration of approximately 5 × 1015 cm−3 and a resistivity of 66 Ω·cm.

28 December 2024 in Micromachines
Verified
Journal Article
Open access
PDF file
ZZZhuang Zhao
Zhuang Zhao
YLY Liu
Y Liu
PLpeixian li
peixian li
XZXiaowei Zhou
Xiaowei Zhou
BYBo Yang
Bo Yang
JBJunchun Bai
Junchun Bai
In this study, we aim to enhance the internal quantum efficiency (IQE) of AlGaN-based ultraviolet (UV) light-emitting diodes (LEDs) by using the short-period AlGaN/GaN superlattice as a tunnel junction (TJ) to construct polarized structures. We analyze in detail the effect of this polarized TJ on the carrier injection efficiency and investigate the increase in hole and electron density caused by the formation of 2D hole gas (2DHG) and 2D electron gas (2DEG) in the superlattice structure. In addition, a dielectric layer is introduced to evaluate the effect of stress changes on the tunneling probability and current spread in TJ. At a current of 140 mA, this method demonstrates effective current expansion. Our results not only improve the performance of UV LEDs but also provide an important theoretical and experimental basis for future research on UV LEDs based on superlattice TJ. In addition, our study also highlights the key role of group III nitride materials in achieving efficient UV luminescence, and the polarization characteristics and band structure of these materials are critical for optimizing carrier injection and recombination processes.

29 July 2025 in Micromachines
Verified
Journal Article
Open access
PDF file
YLY Liu
Y Liu
CCChanghao Chen
Changhao Chen
XZXiaowei Zhou
Xiaowei Zhou
PLpeixian li
peixian li
BYBo Yang
Bo Yang
JBJunchun Bai
Junchun Bai
AlGaN-based high-electron-mobility transistors are critical for next-generation power electronics and radio-frequency applications, yet achieving stable enhancement-mode operation with a high threshold voltage remains a key challenge. In this work, we designed p-AlGaN superlattices with different structures and performed energy band structure simulations using the device simulation software Silvaco. The results demonstrate that thin barrier structures lead to reduced acceptor incorporation, thereby decreasing the number of ionized acceptors, while facilitating vertical hole transport. Superlattice samples with varying periodic thicknesses were grown via metal-organic chemical vapor deposition, and their crystalline quality and electrical properties were characterized. The findings reveal that although gradient-thickness barriers contribute to enhancing hole concentration, the presence of thick barrier layers restricts hole tunneling and induces stronger scattering, ultimately increasing resistivity. In addition, we simulated the structure of the enhancement-mode HEMT with p-AlGaN as the under-gate material. Analysis of its energy band structure and channel carrier concentration indicates that adopting p-AlGaN superlattices as the under-gate material facilitates achieving a higher threshold voltage in enhancement-mode HEMT devices, which is crucial for improving device reliability and reducing power loss in practical applications such as electric vehicles.