Andreas Schubert

Dr. Andreas Schubert


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 November 2024 in Foods
Verified
Journal Article
Open access
PDF file
LLLena Johanna Langendörfer
Lena Johanna Langendörfer
EGElizaveta Guseva
Elizaveta Guseva
PBPeter Bauermann
Peter Bauermann
ASAndreas Schubert
Andreas Schubert
OHOliver Hensel
Oliver Hensel
MDMamadou Diakité
Mamadou Diakité
Legume proteins are increasingly used in structuring various foods under the influence of heating and stirring energy. Based on available studies, this structuring potential is not yet fully understood. This raises the question of the suitability of legume isolates and concentrates for structuring in emulsion gels and the effect of heat and oil on the gel properties. In this study, soy- and pea-based suspensions and emulsions were prepared with the least gelling concentration using different oil concentrations (0%, 7.5%, 15%, 22.5%, and 30%). The viscoelastic properties were measured before and after heating cycles (65 °C and 95 °C). Scanning electron microscopy images complemented the results. All gels measured showed viscoelastic solid behavior. Thermal treatment showed a positive effect on the gel properties for most samples, especially for concentrates (reduction in the loss factor and networking factor > 1). The concentrates showed much higher networking factors and tighter cross-linking than the isolates. The rheological and microstructural properties of the emulsion gels are influenced by a number of factors, such as carbohydrate content, protein chemistry, the protein purification method, and initial viscosity. Moreover, the influence of oil on the rheological properties depends on the material used and whether oil droplets act as an active or inactive filler.

24 April 2024 in Liquids
Verified
Journal Article
Open access
PDF file
KBKay Bischoff
Kay Bischoff
DMDominik Mücke
Dominik Mücke
ASAndreas Schubert
Andreas Schubert
CECemal Esen
Cemal Esen
Ralf HellmannRalf Hellmann
Ralf Hellmann
In this article, the particle concentration of finely dispersed copper(II) oxide nanosuspensions as precursors for reductive laser sintering (RLS) is optimized on the basis of rheological investigations. For this metallization process, a smooth, homogeneous and defect-free precursor layer is a prerequisite for adherent and reproducible copper structures. The knowledge of the rheological properties of an ink is crucial for the selection of a suitable coating technology as well as for the adjustment of the ink formulation. Different dilutions of the nanosuspension were examined for their rheological behavior by recording flow curves. A strong shear thinning behavior was found and the viscosity decreases exponentially with increasing dilution. The viscoelastic behavior was investigated by a simulated doctor blade coating process using three-interval thixotropy tests. An overshoot in viscosity is observed, which decreases with increasing thinning of the precursor. As a comparison to these results, doctor blade coating of planar glass and polymer substrates was performed to prepare precursor layers for reductive laser sintering. Surface morphology measurements of the resulting coatings using laser scanning microscopy and rheological tests show that homogeneous precursor layers with constant thickness can be produced at a particle–solvent ratio of 1.33. A too-high particle content results in an irregular coating layer with deep grooves and a peak-to-valley height Sz of up to 7.8 μm. Precise dilution control allows the fabrication of smooth surfaces with a Sz down to 1.5 μm.