In healthcare facilities, infections caused by Staphylococcus aureus (S. aureus) from textile materials are a cause for concern, and nanomaterials are one of the solutions; however, their impact on safety and biocompatibility with the human body must not be neglected. This study aimed to develop a novel multilayer coating with poly(allylamine hydrochloride) (PAH) and immobilized ZnO nanoparticles (ZnO NPs) to make efficient antibacterial and biocompatible cotton, polyester, and nylon textiles. For this purpose, the coated textiles were characterized with profilometry, contact angles, and electrokinetic analyzer measurements. The ZnO NPs on the textiles were analyzed by scanning electron microscopy and inductively coupled plasma mass spectrometry. The antibacterial tests were conducted with S. aureus and biocompatibility with immortalized human keratinocyte cells. The results demonstrated successful PAH/ZnO coating formation on the textiles, demonstrating weak hydrophobic properties. Furthermore, PAH multilayers caused complete ZnO NP immobilization on the coated textiles. All coated textiles showed strong growth inhibition (2–3-log reduction) in planktonic and adhered S. aureus cells. The bacterial viability was reduced by more than 99%. Cotton, due to its better ZnO NP adherence, demonstrated a slightly higher antibacterial performance than polyester and nylon. The coating procedure enables the binding of ZnO NPs in an amount (<30 µg cm−2) that, after complete dissolution, is significantly below the concentration causing cytotoxicity (10 µg mL−1).
The increase in environmental pollution due to the development of industry and human activity has resulted in intensive development of research on the possibility of its purification. A very effective method is the pollutants’ adsorption from the air and water environment. For adsorption to be effective, materials with a specific structure and a well-developed surface decorated with numerous functionalities, e.g., biocarbons (BC), are necessary. An effective method of activating biocarbons is mechanochemical milling, an environmentally friendly procedure. This paper describes the possibility of using mechanochemical activation (MChA) of non-porous biocarbons to develop surface and porosity for their use in processes of pollutant adsorption. BC was characterized based on N2 adsorption, thermogravimetry (TGA), SEM/EDS imaging, Fourier (ATR-FTIR) and Raman spectroscopies, as well as titration using the Boehm method and determination of zeta potential. The adsorption capacity of BC for methylene blue (MB) was studied. It was proven that the solvent-free MChA made it possible to obtain microporous biocarbons, causing an intensive increase in the surface area and pore volume and the generation of oxygen functionalities. The biocarbons had predominantly acidic (mainly carboxylic) or basic functionalities and exhibited an amorphous structure. BC proved to be effective in adsorbing MB from aqueous solutions.