Penggang Tian

Penggang Tian


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
25 July 2024 in Buildings
Verified
Journal Article
Open access
PDF file
XGXiaoyang Guo
Xiaoyang Guo
ZZZaiyu Zhang
Zaiyu Zhang
Qing SunQing Sun
Qing Sun
PTPenggang Tian
Penggang Tian
Strengthening reinforced concrete (RC) beams with fiber-reinforced polymer (FRP) grids and engineered cement composites (ECCs) can significantly enhance their shear capacity. However, the specific contributions of the components in reinforced RC beams remain unclear, necessitating further investigation into the flexural shear performance of RC beams. The numerical model was used to analyze the flexural shear performance of RC beams strengthened with an FRP grid and ECCs. Subsequently, the parameters affecting the flexural shear performance of beams were discussed. This included the compressive strength of concrete prism, the shear span ratio, the tensile strength of ECCs, the thickness of the ECC cover, the cross-sectional area of the FRP grid, and the number of FRP grid layers. Finally, a calculation formula was established to predict the shear capacity and verified by the outcomes from numerical models and experimental data. The findings indicated that the ECC-strengthened layer significantly contributed to increasing the shear capacity. Additionally, the FRP grids helped to reduce stress concentration in the flexural shear zone, thereby preventing premature concrete cracking. The max load increased by 8.06% when the ECC’s tensile strength increased from 4 MPa to 10 MPa. In addition, increasing the cover thickness from 8 mm to 20 mm caused the peak load to increase by 14.42%. The calculation formula introduced in this research accurately predicts the shear capacity of the oblique section of RC beams.

11 November 2022 in Buildings
Verified
Journal Article
Open access
PDF file
ZZZaiyu Zhang
Zaiyu Zhang
JWJiaqi Wang
Jiaqi Wang
Qing SunQing Sun
Qing Sun
PTPenggang Tian
Penggang Tian
Jian-Tao WangJian-Tao Wang
Jian-Tao Wang
YLYuwei Li
Yuwei Li
The thin-wall high-strength (HS) steel tube can provide strong confinement ability for core concrete due to its high yield strength, so it can achieve the purpose of confining concrete lateral deformation. In order to make full use of the mechanical properties of HS steel tube and concrete, it is necessary to study the axial compressive properties of the concrete-filled HS steel tube (CFHST) with a large diameter-to-thickness ratio (D/t). In this study, the axial compressive capacity of 15 CFHST columns with a large diameter-to-thickness ratio was tested. Then, a series of finite element (FE) models were developed to study the interaction mechanism between steel tube and concrete, the load–strain curves of typical specimens, and the effect of the key parameters. Finally, a new design proposal for CFHST compressive capacity is proposed and compared with EC4, GB50936-2014, and AIJ-97 prediction results. The results showed that the CFHST has good compressive capacity and can effectively confine the lateral deformation of core concrete; the contact pressure appears a stable stage because with a steel tube is difficult to effectively restrain the lateral deformation after steel tube yielding and partial failure of concrete; the existing design code is conservative in predicting the axial compression capacity of the CFHST with large D/t ratio.

2 May 2025 in Preprints.org
Verified
Preprint
Open access
PDF file
Xiao GaoXiao Gao
Xiao Gao
LSLina Shu
Lina Shu
ZMZongfang Ma
Zongfang Ma
PTPenggang Tian
Penggang Tian
Lin PanLin Pan
Lin Pan
DSDear Scholar
Dear Scholar
This study systematically investigates pre-seismic ionospheric anomalies preceding the 2023 Jishishan Ms6.2 earthquake using Total Electron Content (TEC) data derived from BDS Geostationary Orbit (GEO) satellites. Multi-scale analysis integrating Butterworth filtering and wavelet transforms decoupled TEC disturbances into three distinct frequency regimes: (1) High-frequency perturbations (0.56–3.33 mHz) manifest as localized disturbances (amplitude ≤4 TECU, range 1,200 km) with azimuth-dependent N-shaped waveforms, driven by acoustic-gravity waves (AGWs); (3) Low-frequency signals (0.18–0.28 mHz) display phase reversal and non-linear amplitude attenuation following a power-law relationship, indicative of stress-mediated lithosphere-atmosphere-ionosphere (LAI) coupling oscillations. A stark contrast between near-field residuals and far-field weak fluctuations highlights the dominance of large-scale atmospheric gravity waves over localized acoustic disturbances. Geometry-based velocity inversion revealed incoherent high-frequency dynamics (5–30 min) versus anisotropic mid/low-frequency TID propagation (30–90 min) at 175–270 m/s, consistent with AGW theory. Despite concurrent G1-class geomagnetic storm activity, spatial attenuation gradients and velocity anisotropy confirm seismogenic origins, providing critical evidence for earthquake precursor discrimination and advancing multi-scale coupling mechanisms in ionospheric monitoring.

4 July 2025 in Remote Sensing
Verified
Journal Article
Open access
PDF file
Xiao GaoXiao Gao
Xiao Gao
LSLina Shu
Lina Shu
ZMZongfang Ma
Zongfang Ma
PTPenggang Tian
Penggang Tian
Lin PanLin Pan
Lin Pan
DSDear Scholar
Dear Scholar
This study investigates pre-seismic ionospheric anomalies preceding the 2023 Jishishan Ms6.2 earthquake using total electron content (TEC) data derived from BDS geostationary orbit (GEO) satellites. Multi-scale analysis integrating Butterworth filtering and wavelet transforms resolved TEC disturbances into three distinct frequency regimes: (1) high-frequency perturbations (0.56–3.33 mHz) showed localized disturbances (amplitude ≤ 4 TECU, range < 300 km), potentially associated with near-field acoustic waves from crustal stress adjustments; (2) mid-frequency signals (0.28–0.56 mHz) exhibited anisotropic propagation (>1200 km) with azimuth-dependent N-shaped waveforms, consistent with the characteristics of acoustic–gravity waves (AGWs); and (3) low-frequency components (0.18–0.28 mHz) demonstrated phase reversal and power-law amplitude attenuation, suggesting possible lithosphere–atmosphere–ionosphere (LAI) coupling oscillations. The stark contrast between near-field residuals and far-field weak fluctuations highlighted the dominance of large-scale atmospheric gravity waves over localized acoustic disturbances. Geometry-based velocity inversion revealed incoherent high-frequency dynamics (5–30 min) versus anisotropic mid/low-frequency traveling ionospheric disturbance (TID) propagation (30–90 min) at 175–270 m/s, aligning with theoretical AGW behavior. During concurrent G1-class geomagnetic storm activity, spatial attenuation gradients and velocity anisotropy appear primarily consistent with seismogenic sources, providing insights for precursor discrimination and contributing to understanding multi-scale coupling in seismo-ionospheric systems.

15 September 2025 in Buildings
Verified
Journal Article
Open access
PDF file
JNJianhui Niu
Jianhui Niu
YXYupeng Xie
Yupeng Xie
PTPenggang Tian
Penggang Tian
KWKai Wang
Kai Wang
ZTZhiheng Tian
Zhiheng Tian
FYFeng Yue
Feng Yue
This study addresses the critical need for region-specific ground motion selection methods in the Xi’an area by proposing a novel Peak Ground Acceleration (PGA)-based target spectrum, developed through the relationship between PGA and response spectrum attenuation. Based on the relationship between the peak ground acceleration (PGA) and the attenuation of the response spectrum, a PGA target spectrum applicable to the Xi’an area was studied. Using the PGA and code-specified Standard Spectrum as the target spectrum, earthquake records were selected and their amplitudes scaled by employing various methods, including fundamental period scaling, average spectral ratio scaling, equal spectral intensity scaling, minimum squared error scaling, and minimum moving average scaling. Based on the 70 ground motion records obtained from the five scaling methods applied to the two target spectra (grouped into 10 distinct sets), the dynamic time history analysis was conducted for a frame-core tube structure; the effects of different scaling methods and different target spectra were investigated on the dispersion of floor displacement, interstory drift ratio and interstory shear. The results show that the spectral value of the PGA target spectrum at the peak is 54% higher than that of the code-specified spectrum, while in the long-period range, the acceleration values of the PGA target spectrum are comparatively smaller, only about 50% of those of the code spectrum. For structural response, the code target spectrum is more conservative compared with the PGA target spectrum, and the minimum moving average method is the least sensitive to different target spectra. This work offers preliminary insights that may contribute to the optimization of ground motion selection in regionally tailored seismic design practices.

8 August 2025 in Buildings
Verified
Journal Article
Open access
PDF file
PTPenggang Tian
Penggang Tian
YHYufei Han
Yufei Han
KWKai Wang
Kai Wang
JWJiajia Wang
Jiajia Wang
ZTZhiheng Tian
Zhiheng Tian
EXErgang Xiong
Ergang Xiong
Considering the effect of the flange on the shear capacity of reinforced concrete (RC) beams without stirrups, a shear capacity calculation formula based on the crack sliding model is proposed for RC beams without stirrups in this paper. Test data of 444 rectangular section beams and 172 T-beams were collected to verify this calculation theory, and the calculation results were compared with domestic and international design codes. The collected datasets were analyzed using five common machine learning models. The results show that the shear capacity calculation method proposed by the codes of each country is in good agreement with the test results. Compared to the calculation of the codes, the addressed calculation method in this study is more accurate and can effectively account for the contribution of the T-beam flange to the shear capacity. The machine learning models selected in this paper exhibit desirable accuracy on the test set, which demonstrates the applicability of the machine learning models in the calculation of shear capacity for reinforced concrete beams.