We present novel results on thermocavitation using a CW medium-power near infrared laser (λ=975 nm) focused into a saturated copper nitrate saline solution. Due to the large absorption coefficient at the laser wavelength, the solution can be heated to its superheat limit (T_sh~270-300°C). Superheated water undergoes explosive phase transition around T_sh producing approximately half-hemispheric bubbles (γ~0.5) in close contact with the substrate. We report the temporal dynamic of the cavitation bubble, which is much shorter than previously reported under similar conditions. It was found that the bubble radius and pressure wave amplitude emitted on bubble collapse decreases exponentially with the power laser. Thermocavitation can be a useful tool for the generation of ultrasonic waves and controlled ablation for use in high-resolution lithography.

In this work, we present a study of the nonlinear absorption properties from different gold nanorod (NR) systems in aqueous suspension. The NRs were obtained with the bottom-up protocol by the seed-mediated growth method (SMG), using Ag⁺ ions at different concentrations, and CTAB as surfactant. By using this method, aspect ratios between 2 and 5 were obtained. The transverse surface plasmons (TSP) are located between 514 – 535 nm, while the longitudinal surface plasmons (LSP) are between 639 – 921 nm, for the different samples studied. The Z-scan technique was implemented for open (OA) and closed (CA) aperture at 532 and 1064 nm, with laser pulses of 26 ps, for vertical and horizontal polarizations, with respect to the incidence plane (horizontal). At 532 nm all samples showed saturable absorption (SA), while for samples with LSP near 1064 nm, such effect was observed only at low-energy pulse experimental conditions. In the high-energy pulse regime, an apparent reverse-saturable absorption (RSA) was observed for both wavelengths. However for 532 nm, it was possible to determine that this effect results from structural changes in the samples, which are manifested through the behavior of nonlinear absorption and refraction curves. These results were used to determine the irradiances to which NRs can be modified by photodegradation.

In this work we demonstrate efficient quality control of a variety of gasoline and ethanol (gasohol) blends using a multimode interference (MMI) fiber sensor. The operational principle relies on the fact that the addition of ethanol to the gasohol blend reduces the refractive index (RI) of the gasoline. Since MMI sensors are capable of detecting small RI changes, the ethanol content of the gasohol blend is easily determined by tracking the MMI peak wavelength response. Gasohol blends with ethanol contents ranging from 0% to 50% has been clearly identified using this device, which provides a linear response with a maximum sensitivity of 0.270 nm/% EtOH. The sensor can also distinguish when water incorporated in the blend has exceeded the maximum volume tolerated by the gasohol blend, which is responsible for phase separation of the ethanol and gasoline and could cause serious engine failures. Since the MMI sensor is straightforward to fabricate and does not require any special coating it is a cost effective solution for real time and in-situ monitoring of the quality of gasohol blends.