As a result of the thermo-mechanical impact during welding, distortions are generated in welded structures. These distortions significantly influence the geometric and dimensional accuracy of welded structures, in many cases lowering their working characteristics and reliability. An optimal design for welded structures is a prerequisite for increased reliability and reduction in manufacturing cost, and such an optimal design can be achieved knowing the distortions in weldments. Despite the fact that pulsed metal inert gas welding and metal active gas welding have been broadly applied in the last few decades, nowadays, few manufacturers, for instance, Fronius, EWM, Redco, and Perfect Power Welders, offer such an option for manual arc welding. This work aims to determine the influence of the parameters of pulsed welding modes on distortions that are generated during manual arc welding. Two different inverter welding power sources were used, and the welding distortions were measured by 3D scanning. The results showed that the pulsed mode during manual arc welding led to a reduction in distortions compared to the conventional welding mode. The crucial part of the manual welding system proved to be the qualification and performance of the welder.
As high strength and ultra-high strength steels are widely used in all kinds of modern welded constructions, a lot of research is carried out to investigate the mechanical properties of weldments of these steels but there is a scarce information on such important characteristic as their corrosion behaviour. This research focuses on the corrosion behaviour of weld metal of weldments of S906QL and S700MC steels. Weld metal was tested electrochemically in a 3,5% NaCl aqueous solution via potentiodynamic scan to determine corrosion rate and its dependence on welding gap. No influence of welding gap on corrosion rate was found but the experimental results suggested that corrosion rate depended on the chemical composition of filler material and the microstructure of weld metal.
As high-strength and ultra-high-strength steels are widely used in all kinds of modern welded constructions, a lot of research is carried out to investigate the mechanical properties of the weldments of these steels, but there is little information on such important characteristics as their corrosion behaviour. This research focuses on the corrosion behaviour of the weld metal of the weldments of S906QL and S700MC steels. The weld metal was tested electrochemically in a 3.5% NaCl aqueous solution via a potentiodynamic scan to determine the corrosion rate and its dependence on the welding gap. No influence of the welding gap on the corrosion rate was found, but the experimental results suggested that the corrosion rate depended on the chemical composition of the filler material and the microstructure of the weld metal.
Stirring material during the process of friction stir welding, as well as the temperature at which the joining process is carried out are the main factors that determine the possibility to produce weldments with defined mechanical properties. While the shape and the dimensions of the instrument are primarily related to the blending manner, the temperature is mostly dependent on the welding modes. It is known that there is a temperature range for every alloy, at which it is possible to produce a flawless Join. That’s why the temperature determination at the welding zone is exceptionally important. There are different direct and indirect approaches to temperature determination, and the present report looks at the possibility for indirect temperature determination using examination of the changes in mechanical properties of an aluminium alloy EN AW-1050A H24 (EN AW-Al 99.5). For this purpose, the mechanical properties of the alloy after recrystallization annealing at different temperatures were determined and compared to the mechanical properties of the alloy after friction stir welding using different welding modes.
22 June 2024 in ENVIRONMENT. TECHNOLOGIES. RESOURCES. Proceedings of the International Scientific and Practical Conference
The study describes the Monte Carlo modelling of the ablation depth during the laser marking process. The effect of grain size on the resulting roughness is studied. The results were validated by experiments with model samples of pure iron with different grain sizes. The influence of the laser power, speed and raster distance were also studied and commented.