Recent upgrades to the FIDA (fast-ion D-alpha) diagnostic at ASDEX Upgrade are discussed. The diagnostic has been extended from three to five line of sight arrays with different angles to the magnetic field, and a spectrometer redesign allows the simultaneous measurement of red- and blue-shifted parts of the Doppler spectrum. These improvements make it possible to reconstruct the 2D fast-ion velocity distribution from the FIDA measurements by tomographic inversion under a wide range of plasma parameters. Two applications of the tomography are presented: a comparison between the distributions resulting from 60 keV and 93 keV neutral beam injection and a velocity-space resolved study of fast-ion redistribution induced by a sawtooth crash inside and outside the sawtooth inversion radius.
This paper describes a new method to derive, from soft x-ray (SXR) tomography, robust estimates of the core displacement, growth rate and frequency of a 1/1 sawtooth crash precursor. The method is valid for very peaked SXR profiles and is robust against both the inversion algorithm and the presence of tungsten in a rotating plasma. Three typical ASDEX Upgrade crashes are then analysed. In all cases a postcursor is observed, suggesting incomplete reconnection. Despite different dynamics, in all three cases the growth rate of the core displacement shows similar features. First, it is not constant, supporting the idea of non-linear growth. Second, it can be divided into clearly identified phases with quasi-constant growth rates, suggesting sudden change of growth regime rather than smooth transitions. Third, its evolution is non-monotonic, with phases of accelerated growth followed by damped phases. This damping is interpreted for two cases respectively as an effect of fast ions and of mode coupling, based on the result of a MHD simulation. The mode frequency is observed in all cases to be closely related to the plasma bulk rotation profile, with little or no visible effect of the electron diamagnetic drift frequency. The onset criterion could not be clearly identified and it is shown that the role of the pressure gradient is not as expected from a naive extrapolation of the linear stability theory.
28 November 2014 in Plasma Physics and Controlled Fusion
The successful operation of fusion reactors requires plasma scenarios with good core confinement and acceptable first wall heat loads that are stable and robust to external perturbations. This poses both physical and technological challenges. One of the technologies that addresses these challenges is a complex feedback control system that supports advances in physical understanding and helps to ensure stable operating conditions. The operation of marginally stable plasmas often leads to off-normal events (such as disruptions) and feedback control can prevent these to some extent. This contribution gives an overview of the main results of the development and operation of the feedback control algorithms on ASDEX Upgrade (AUG). Fueling actuators, using a combination of gas valves and pellet injection, can simultaneously control neutral density of the divertor and the density of the plasma core above the Greenwald limit. Impurity injection is employed to control the position of the X-point radiator, allowing the creation of an ELM-suppressed H-mode with high radiation fraction. Heating actuators are used to control the plasma energy content, which supports advanced tokamak experiments and enables stable I-mode operation, and the electron temperature control, which supports turbulence studies. In control technology, AUG has pioneered the use of virtual actuators, which allow effective use of the limited number of heating actuators, adaptive control policies, and exception handling. Such technologies will also be used in ITER. Advanced nonlinear state observers (RAPTOR, RAPDENS) and codes to evaluate the power deposition properties (RABBIT, TORBEAM) are available for routine use in the AUG feedback controllers. Extensive use of the AUG discharge control system further enhances the research capabilities of this machine.