Red mud (RM) is a waste material obtained during the production of aluminum from bauxite minerals. RM causes environmental pollution due to its high alkaline properties. Therefore, RM materials are stored in waste reservoirs. As production continues, the number of required waste reservoirs increases day by day. This study aims to utilize RM waste material in construction structures to contribute to the economy. The research investigates the potential use of RM waste material as road fill material. RM was improved using another waste material of fly ash (FA) since RM has low strength. Atterberg limit tests, compaction tests, unconfined compression tests, CBR tests, and SEM analyses were conducted on stabilized RM samples. In the physical properties of stabilized RM, Atterberg limits and optimum moisture content increase and density decreases since FA content increases. In the mechanical properties of stabilized RM, unconfined compressive strength, initial and secant modulus of elasticity, and California bearing ratio increase and maximum peak strain decreases since FA content and curing period increase. SEM images prove the increase in mechanical properties due to the cementation products (CSH and CAH gels) formed in the microstructure of stabilized RM. The results showed that RM waste stabilized with FA can be used as road subgrade material.
This study provides a comprehensive evaluation of red mud as a sustainable material for road base construction, particularly in combination with bottom ash. Red mud, a by-product of the Bayer process used in alumina extraction, is known for its high alkalinity and heavy metal content. For this reason, this waste material causes environmental challenges. Red mud sourced from the Eti Aluminum Factory in Seydişehir, Konya (Turkey), was stabilized with bottom ash. Then, these waste materials were tested through a number of experiments, such as in relation to their Atterberg limits, compaction characteristics, unconfined compressive strength (UCS), California bearing ratio (CBR), and microstructure through a scanning electron microscopy (SEM) analysis. The results highlight that the UCS of stabilized red mud samples significantly improved with the addition of bottom ash and longer curing periods. Specifically, the UCS values increased from 0.5 MPa to 2.5 MPa after 28 days of curing. Moreover, RM specimens stabilized with 25% bottom ash achieved a CBR value of 146.64% after 28 days, far exceeding Turkey’s road fill material requirement, which mandates a minimum unsoaked CBR value of 15%. These findings indicate that red mud stabilized with bottom ash not only meets but exceeds the structural requirements for road base materials. This approach provides a sustainable solution for the environmental management of red mud while contributing to infrastructure development. Through the recycling of these industrial by-products, this study presents a viable method to reduce waste and support economic and environmental sustainability in road construction projects.