The production of cost-effective novel materials for PV solar cells with long-term stability, high energy conversion efficiency, enhanced photon absorption, and easy electron transport has stimulated great interest in the research community over the last decades. In the presented work, Cu/Cu2S-MWCNTs nanocomposites were produced and analyzed in the framework of potential applications for PV solar cells. Firstly, the surface of the produced one-dimensional Cu was covered by Cu2S nanoflake. XRD data prove the formation of both Cu and Cu2S structures. The length and diameter of the one-dimensional Cu wire were 5–15 µm and 80–200 nm, respectively. The thickness of the Cu2S nanoflake layer on the surface of the Cu was up to 100 nm. In addition, the Cu/Cu2S system was enriched with MWCNTs. MWCNs with a diameter of 50 nm interact by forming a conductive network around the Cu/Cu2S system and facilitate quick electron transport. Raman spectra also prove good interfacial coupling between the Cu/Cu2S system and MWCNTs, which is crucial for charge separation and electron transfer in PV solar cells. Furthermore, UV studies show that Cu/Cu2S-MWCNTs nanocomposites have a wide absorption band. Thus, MWCNTs, Cu, and Cu2S exhibit an intense absorption spectrum at 260 nm, 590 nm, and 972 nm, respectively. With a broad absorption band spanning the visible–infrared spectrum, the Cu/Cu2S-MWCNTs combination can significantly boost PV solar cells’ power conversion efficiency. Furthermore, UV research demonstrates that the plasmonic character of the material is altered fundamentally when CuS covers the Cu surface. Additionally, MWCN-Cu/Cu2S nanocomposite exhibits hybrid plasmonic phenomena. The bandgap of Cu/Cu2S NWs was found to be approximately 1.3 eV. Regarding electron transfer and electromagnetic radiation absorption, the collective oscillations in plasmonic metal-p-type semiconductor–conductor MWCNT contacts can thus greatly increase energy conversion efficiency. The Cu/Cu2S-MWCNTs nanocomposite is therefore a promising new material for PV solar cell application.
This work presents an optimisation study of silicon surface preparation for silicon heterojunction solar cells (SHJ) fabricated from surface-damaged wafers, aiming to ensure minimal surface defects and improved passivation at the crystalline silicon-hydrogenated amorphous silicon (c-Si/a-Si:H) interface. KOH etching conditions were optimized to remove diamond‑wire‑saw (DWS) damage on c‑Si while tuning nanoscale faceting for improved interface passivation. Namely, KOH 45% was used to smooth the surface and remove saw damage, while KOH 5% generated approximately 20 nm pyramidal‑like features in a single‑step, IPA‑free process. For the fabrication of SHJ solar cells with an Aluminium Back Surface Field (Al-BSF), intrinsic and n-type doped a-Si:H layers were deposited by plasma-enhanced chemical vapor deposition (PECVD) on the front side of the devices. Two different (i)a-Si:H films, one dense, deposited with 50% hydrogen dilution, (id)a-Si:H, and the other, under-dense, using pure silane gas, (iud)a-Si:H, were used in different solar cells. A relative improvement of 18% in implied PCE (Suns‑Voc) was observed for KOH 5% with dense (id)a‑Si:H versus KOH 45%, which was attributed to the effect of nanoscale faceting created on the c‑Si surface by the 5% KOH treatment.