Perovskite solar cells are attracting more and more attention due to their higher absorption and low cost. However, fabricating the perovskite film with high crystallinity and ideal morphology, which presents large-size and uniform particles with fewer grain boundaries, still needs further improvement. Herein, we introduce MAPbCl3 crystals into the PbI2 film in the sequential deposition process, which obtained the controlled crystallization in perovskite films. The perovskite films induced by MAPbCl3 have stronger crystallinity, fewer defect states, and larger grain size, reducing carrier recombination and improving carrier transfer. The optimized perovskite solar cell (PSC) has achieved a power conversion efficiency of 20.97%. Furthermore, the stability of PSCs has also been enhanced due to the reduced grain boundaries impeding moisture diffusion. This strategy can be applied in other solution-based fabrication processes to improve the photovoltaic performance of PSCs.
In this paper, a method to obtain the CuInGaSe2 (CIGS) absorber layer with an appropriate selenium content is put forward, in which a Se-rich target is used to deposit a CIGS thin-film and this film is annealed in a Se-free inert atmosphere. The key issue of this method is the preparation of a Se-rich target with a homogeneous composition and a high-density. The formation mechanism of CuInSe2 and CuGaSe2 is investigated and the results point to the intermediate phase Cu2−xSe playing a role of a nucleation core. The sintering densification trajectory of the target with the addition of extra selenium is researched. Additionally, an effective way to avoid the sintering defects is proposed. Finally, a conversion efficiency of 11.2% for the CIGS solar cell is reached by sputtering from the obtained Se-rich target.
The scalable production of high-quality perovskite thin films is pivotal for the industrialization of perovskite thin film solar cells. Consequently, the solvent system employed for the fabrication of large-area perovskite films via coating processes has attracted significant attention. In this study, a solvent system utilizing a volatile solvent as the primary reagent has been developed to facilitate the rapid nucleation of volatile compounds. While adding the liquid Lewis base dimethylformamide (DMF) can help to improve the microstructure of perovskite films, its slow volatilization renders the crystal growth process uncontrollable. Based on the solvent system containing DMF and ethanol (EtOH), introducing a small amount of NH4Cl increases the proportion of the intermediate phase in the precursor films. This not only results in a controllable growth process for the perovskite crystals but also contributes to the improvement of the film microstructure. Under the simulated illumination (AM1.5, 1000 W/m2), the photoelectric conversion efficiency (PCE) of the inverted solar cells has been improved to 20.12%. Furthermore, after 500 hours of continuous illumination, the photovoltaic device can retain 95.6 % of the initial, indicating that the solvent system is suitable for the scalable fabrication of high-quality FAPbI3 thin films.
In this study, a feasible strategy is proposed for directly depositing high-quality Cu(In,Ga)Se2 (CIGS) films using Na-doped targets in a selenium-free atmosphere to boost the power conversion efficiency (PCE) of CIGS solar cells. Introducing a small amount of sodium dopant effectively promoted the textured growth of CIGS crystals in the prepared films, resulting in larger grain sizes and a smoother interface. The higher MoSe2 content at the CIGS/Mo interface increased the carrier lifetime in the films. In addition, sodium doping increased the proportion of Se atoms on the film surface and reduced the concentration of defects caused by the direct sputtering of the films in the selenium-free atmosphere. Therefore, the separation and transportation of photo-generated carriers in the devices were effectively enhanced. Using the optimized parameters, a record-high PCE of 17.26% was achieved for the 7.5% Na-doped devices, which represents an improvement of nearly 63%.
About Me
Preparation and study of high-efficiency photovoltaic thin-film materials.
Preparation and study of high-efficiency photovoltaic thin-film materials.