The dehydration behavior of caesium dihydrogen phosphate CsH2PO4 was investigated in the temperature range of 230 °C to 260 °C under high humidity, conditions of particular relevance to the operation of fuel cells based on this electrolyte. The onset temperature of dehydration was determined from changes in ionic conductivity on heating and confirmed by weight change measurements under isothermal conditions. The relationship between the onset temperature of dehydration (Tdehy) and water partial pressure (p H2O ) was determined to be log(p H2O /atm = 6.11(±0.82) − 3.63(±0.42) × 1000/(Tdehy/K), from which the thermodynamic parameters of the dehydration reaction from CsH2PO4 to CsPO3 were evaluated. The dehydration pathway was then probed by X-ray powder diffraction analysis of the product phases and by thermogravimetric analysis under slow heating. It was found that, although the equilibrium dehydration product is solid caesium metaphosphate CsPO3, the reaction occurs via two overlapping steps: CsH2PO4 → Cs2H2P2O7 → CsPO3, with solid caesium hydrogen pyrophosphate, Cs2H2P2O7, appearing as a kinetically favored, transient phase.
8 November 2013 in Journal of Materials Chemistry A
The solid acid compound CsH2PO4 (CDP) adopts a cubic structure of high conductivity above 228 °C, rendering it attractive as a fuel cell electrolyte for intermediate temperature operation. This superprotonic phase is stable from the phase transition temperature, Ts, to the dehydration temperature, Td, where the latter depends on water vapor pressure (e.g. Td = 290 °C at p H2O = 0.8 atm). In this work we examine the possibility of modifying these temperatures and thereby, amongst other characteristics, fuel cell operating conditions by introduction of Rb and K as substituents for Cs in CDP. The phase behavior of the Cs1−xRbxH2PO4 and Cs1−xKxH2PO4 pseudo-binary systems are determined by in situ X-ray diffraction (XRD) and thermal analysis. It is found that RbH2PO4 (RDP) and CDP are entirely miscible both below and above the transition to the cubic phase. With increasing Rb concentration, Ts increases and Td decreases. In contrast, K has limited solubility in CDP, with a 27 at.% solubility limit in the cubic phase, and both Ts and Td decrease with K content. The eutectoid temperature in the Cs1−xKxH2PO4 system is 208 ± 2 °C and the K solubility decreases sharply below this temperature. In both systems, conductivity decreases monotonically with increasing substituent concentration. Furthermore, even after normalization for cation size, the impact of K is greater than that of Rb, suggesting local disruptions to the proton migration pathway, beyond global changes in unit cell volume. Although this investigation shows unmodified CDP to remain the optimal fuel cell electrolyte material, the study provides a possible framework for elucidating proton transport mechanisms in superprotonic conductors.
To investigate the relationship between microstructure, chemical composition, and thermoelectric properties, we have applied graded temperature heat treatments to recently developed τ1-Al2Fe3Si3-based thermoelectric (FAST) materials formed by a peritectic reaction. We investigated microstructures, chemical compositions, and Seebeck coefficients as continuous functions of heat treatment temperature. The τ1 phase can become p- and n-type semiconductors without doping by changing the Al/Si ratio. The Seebeck coefficient was maximized, exceeding |S| > 140 μVK−1 for both p- and n-type materials, by heat treatment at 1173 K for 24 h through microstructural optimization. These results show that combining the graded temperature heat treatments and spatial mapping measurements of thermoelectric properties gives effective routes to determine the suitable heat treatment temperature for materials with multiphase microstructure.