The present study investigates the microstructural, mechanical, and tribological properties of Inconel 718 alloy produced by selective laser melting (SLM) in relation to heat treatment. The SLM-processed samples received a two-step heat treatment: solutionizing at 1065 °C for 1 h, followed by double aging at 720 °C for 8 h and 620 °C for 6 h. The as-built sample exhibited a grain structure mostly characterized by fine Laves phases, while the hardening phases γ′ ((Ni3 (Al, Ti)) and γ″ (Ni3Nb) precipitated during the heat treatment. Following heat treatment, a transformation in crystallographic texture and dislocation density occurred, yielding a random texture and reduced dislocation density, particularly in the XZ direction, attributed to the formation of new grains via recrystallization in the microstructure. The grain size in the XY plane decreased following heat treatment, whereas the texture in the direction remained unaffected. The heat-treated samples had significantly higher tensile strength (1330 MPa vs. 960 MPa) and hardness (530 HV vs. 340 HV) relative to the as-built samples. The wear resistance of heat-treated samples surpassed that of the as-built sample due to enhanced mechanical properties resulting from the fine and dispersed γ′ and γ″ precipitates in the microstructure with heat treatment.
Severe wear is a frequent cause of failure in industrial machinery that lacks adequate surface protection. Iron-based alloys offer an attractive combination of hardness, fracture toughness, and low cost for addressing this problem. In this study, a CALPHAD-based thermodynamic approach was employed to design a novel Fe-M(Nb,Mo,Cr)-C-B alloy, which was cast and subsequently processed into powders by gas atomization. The powders showed a Hall flow rate of 27 s/50 g and an angle of repose of 26°. The alloy composition was determined by optical emission spectroscopy, X-ray fluorescence (Nb), and inductively coupled plasma mass spectrometry (B), while X-ray diffraction confirmed the presence of α-iron and complex borocarbide phases. SEM/EDS analysis revealed a spherical powder morphology and a refined, uniformly distributed borocarbide microstructure induced by rapid solidification. Electron backscatter diffraction indicated a near-random crystallographic texture, and grain orientation spread maps revealed increasing internal strain with decreasing particle size. Nanoindentation gave localized hardness values of approximately 1330–1590 HV0.0005, which decreased with increasing particle size. The refined borocarbide-reinforced microstructure, high localized hardness, and good flowability suggest that the developed powder is a candidate feedstock for wear-resistant coating applications, although its coating and wear performance remain to be verified.