Soluble organics (SBC-L) from Santanghu bituminous coal (SBC) were obtained by extracting the coal with a mixed solvent of CS2 and acetone (v/v′ = 1:1). Catalytic hydrogenation of SBC-L was carried out using isopropanol as the solvent and prepared bimetallic material (Ni-Mo/γ-Al2O3) as the catalyst, and the hydrogenation product (SBC-LIP320) was obtained. Gas chromatography-mass spectrometry (GC-MS) was used to compare the difference in the composition and distribution of SBC-L and SBC-LIP320; thus, the effect of the used catalyst on the hydrogenation performance and heteroatom removal of SBC-L can be investigated. Results showed that the organic compounds in SBC-L and SBC-LIP320 could be classified into aliphatic hydrocarbons (AHS), arenes, oxygen-containing organic compounds (OCOCs), nitrogen-containing organics (NCOCs), and compounds containing other heteroatoms (OHACOCs). The relative contents of AHS and arenes detected in SBC-LIP320 were higher than those of SBC-L, while the contents of OCOCs, NCOCs, and OHACOCs decreased, and no S-containing compounds could be detected in SBC-LIP320. It can be concluded that the prepared catalyst presents good de-oxygenation, de-sulfurization, de-nitrogenation, and hydrocracking performance.
Fly ash (FA) from Zhundong coal combustion features high alkali/calcium content and a low Si/Al ratio, limiting its potential for conventional utilization. To enable its high-value application, six size-fractionated samples (FA1–FA6) were characterized via laser particle sizing, SEM-EDS, XRF, XRD, FT-IR, and TGA, to elucidate particle-size-dependent physicochemical and thermal properties. The results show that the size distribution centered at 48–150 μm (~71%). With decreasing size, the morphology shifted from irregular aggregates to smooth vitreous spheres. The chemical composition exhibits significant elemental segregation; the SiO2 content decreases with decreasing particle size, while active components such as CaO, MgO, and Fe2O3 are significantly enriched in fine particles. The thermal conversion behavior is regulated by particle size: The combustion reaction under an air atmosphere conforms to the second-order kinetic model, with the activation energy decreasing from 192.73 kJ·mol−1 for coarse particles (>150 μm) to 63.53 kJ·mol−1 for fine particles (<43 μm); under a nitrogen atmosphere, the weight loss originates from the removal of structural water and the decomposition of carbonates, and fine particles exhibit a higher pyrolysis activation energy (504.15 kJ·mol−1) in the high-temperature stage (850–940 °C) due to being rich in high-crystallinity carbonates. The results of this study elucidate the structure–activity relationship of “particle size-composition-activity” for Zhundong coal fly ash and propose a graded utilization scheme where coarse fractions are suitable for low-grade building fillers, while fine fractions can be used as feedstocks for coal pyrolysis catalysts and functional adsorbents, providing a theoretical basis for its targeted resource utilization based on particle size fractionation.
Refinery water treatment sludge (RWTS) is a hazardous organic waste that requires effective treatment prior to disposal, yet its resource potential remains underexplored. In this work, the physicochemical properties and pyrolysis product distribution of RWTS collected from a refinery in Xinjiang, China, were systematically investigated using Fourier transform infrared (FTIR), thermogravimetric and derivative thermogravimetric (TG-DTG) analysis, and pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS). Proximate analysis revealed a high volatile matter content (64.69%), while ultimate analysis showed a carbon content of 49.18% and an H/C molar ratio of 1.80, indicating that RWTS is a hydrocarbon-rich feedstock. FTIR analysis demonstrated that aliphatic C-H groups dominate the organic structure, while aromatic C=C and oxygen-containing functional groups are present in minor proportions. TG-DTG profiles revealed three distinct decomposition stages, with maximum weight-loss rates at 305, 445, and 655 °C, corresponding to the staged release of volatile compounds and the progressive cleavage of organic structures. Py-GC/MS analysis further showed a pronounced temperature dependence of the pyrolysis products. At 305 °C and 445 °C, the products were mainly alkanes, with relative contents of 84.9% and 89.1%, respectively, mainly distributed in the C11–C30 carbon-number range. In contrast, at 655 °C, extensive thermal cracking of long-chain aliphatic hydrocarbons generated large amounts of light hydrocarbons (C4–C10, 42.20%) and alkenes (56.0%), accompanied by the formation of monocyclic aromatic hydrocarbons. Results demonstrate that increasing the pyrolysis temperature shifts the dominant conversion pathway from the volatilization of indigenous hydrocarbons to the thermal cracking of long-chain aliphatic structures, providing new insights into the thermal conversion mechanism and resource utilization of RWTS.
Naomaohu lignite (NL) from Hami, Xinjiang, was ultrasonically extracted with a mixed solvent of CS2 and acetone (in equal volumes) to obtain the extract residue (ER).
Vacuum residue (VR) is one of the more difficult heavy fractions to process in petroleum refining, and the development of clean utilization technologies for vacuum residue has become a major research focus in the petrochemical industry. This paper discusses the compositional and structural characteristics of vacuum residue from Karamay (KVR) using methods such as ultimate analysis, FTIR, and TG-DTG. The thermal gravimetric kinetics analysis was conducted based on TG-DTG curves at different heating rates. Ultimate analysis revealed that KVR has a high H/C atomic ratio (1.84), and combined with the strong peaks at 2920 cm−1 and 2850 cm−1 in its infrared spectrum, it indicates that KVR is mainly composed of aliphatic compounds, with aromatic compounds being relatively few. High-temperature simulated distillation showed that KVR had a broad boiling-range distribution, with the temperature corresponding to a cumulative recovery of 86.4% exceeding 720 °C, indicating the presence of a certain proportion of ultra-high-boiling components in KVR. The Coats–Redfern kinetic model shows significant variations in activation energy (Ea) at different temperature ranges and reaction orders. Kinetic studies using non-model methods show smaller differences in Ea derived from four different non-model methods. Overall, KVR’s pyrolysis process is complex, with Ea ranging between 100 and 300 kJ/mol.