The reliability of GaN-based devices operating under high temperatures is crucial for their application in extreme environments. To identify the fundamental mechanisms behind high-temperature degradation, we investigated GaN-on-sapphire Schottky barrier diodes (SBDs) under simultaneous heating and electrical biasing. We observed the degradation mechanisms in situ inside a transmission electron microscope (TEM) using a custom-fabricated chip for simultaneous thermal and electrical control. The pristine device exhibited a high density of extended defects, primarily due to lattice mismatch and thermal expansion differences between the GaN and sapphire. TEM and STEM imaging, coupled with energy-dispersive X-ray spectroscopy (EDS), revealed the progressive degradation of the diode with increasing bias and temperature. At higher bias levels (4–5 V) and elevated temperatures (300–455 °C), the interdiffusion and alloying of the Au/Pd Schottky metal stack with GaN, along with defect generation near the interface, resulted in Schottky contact failure and catastrophic device degradation. A geometric phase analysis further identified strain localization and lattice distortions induced by thermal and electrical stresses, which facilitated diffusion pathways for rapid metal atom migration. These findings highlight that defect-mediated electrothermal degradation and interfacial chemical reactions are critical elements in the high-temperature failure physics of GaN Schottky diodes.
18 December 2024 in IEEE Transactions on Electron Devices
The superjunction (SJ), historically a silicon technology, has emerged as an effective method to increase blocking voltage with reduced on-resistance. A previous report of experimentally demonstrated lateral GaN super-heterojunction (SHJ) MOSFETs indicated potential for 10-kV-range low-loss and fast switching. The charging and discharging of p-type regions with holes utilized for creating a charge-balanced drift region may influence device switching time. In this work, a TCAD transient simulation study of an SHJ-FET is presented to understand: 1) the SHJ FET switching behavior and 2) how gate-to-drain spacing, hole mobility, acceptor ionization energy, and hole capture rate by p-type layer ionized acceptors influence switching time. It is revealed that device turn-on is driven by electrostatic potential in the p-GaN. A closed-form analytical model is derived to relate the turn-on time with key device and material parameters. Both TCAD simulation and the analytical model indicate that the turn-on time is in microsecond range for 10-kV-class devices.
Among GaN lateral power devices, with proper E-field management, the breakdown occurs in the device isolation region rather than the active region. In this paper, we investigate field-dependent carrier transport in the isolation structures. Isolation test structures with variations in buffer doping, un-intentionally doped (UID) GaN thickness, and implantation conditions were fabricated. Electrical characterization was performed over a wide range of voltage and temperature. With varying UID GaN thickness and buffer doping, the leakage current and breakdown characteristics remain the same for a specific implantation condition, indicating that the leakage conduction and breakdown are governed by the implanted GaN region. Analysis of the temperature-dependent I–V reveals that carrier transport in the implanted GaN can be well explained by hopping conduction, involving three distinctive regions of operation depending on the E-field. At low E-field, carrier transport is ohmic, consistent with variable range hopping, driven by thermal activation. At medium E-field, a field enhanced thermally activated hopping is observed, following σ ∼ σ(T)exp(E). At high E-field, activation-less hopping is visible, following σ ∼ exp(−1/E), which occurs above a critical E-field limited by localization length.
9 June 2026 in Journal of Physics D: Applied Physics
Gallium nitride-based electronics are expected to be highly radiation tolerant because of the wide bandgap, high bond-strength and dynamic annealing features of the material. In addition, the absence of a gate oxide in junction field effect transistors reduces accumulation of traps under ionizing radiation. However, these features may not offer immunity to single event effects, which is a unique damage mode in space applications. This study examines single event effect degradation in GaN junction field effect transistors as well as Ohmic and Schottky diodes using pulsed laser exposure (λ = 586 nm, full width at half maximum (FWHM) pulse width ~250 fs, 1 kHz frequency) for controllable characterization required to explore the fundamentals behind single event sensitivity. The single event transients occur on nanosecond time scales and exhibit maximum sensitivity in regions where n-type GaN is exposed and subjected to strong internal electric fields. These findings suggest that exposed n-type GaN layers represent critical vulnerability points requiring mitigation strategies for radiation-hardened GaN device design.
GaN junction field-effect transistors (JFETs) were fabricated and subjected to 333.7 MeV gold (Au) ion irradiation to investigate the effects of swift heavy ions on device performance. Electrical characterization following irradiation revealed a significant and permanent increase in off-state leakage current. The leakage was attributed to a vertical conduction mechanism, likely to originate from latent ion tracks formed within the device during SHI exposure. The results indicate a latent track-induced vertical leakage path in GaN JFETs under SHI irradiation. Temperature-dependent current–voltage measurements indicated a voltage-dependent activation energy, suggesting a field-assisted transport process. Device simulations reproduced the experimental leakage behavior and identified the critical leakage path at the p+-GaN/p-GaN region, where the local electric field is most intense. The conduction mechanism was found to be consistent with the Poole–Frenkel emission model, from which a barrier height of approximately 0.38 eV was extracted. These findings offer insights into SHI-induced degradation in GaN devices and provide guidance for designing radiation-hardened GaN electronics for space applications.