2 January 2024 in IEEE Transactions on Electron Devices
This article reports on two generations of GaN-on-sapphire super-heterojunction (SHJ) transistors, aiming at the realization of 10-kV class power transistors with low static and dynamic ON-resistance. First generation (Gen. 1) GaN SHJ-FETs used a single 2-D electron gas (2DEG) channel design with Schottky gate. Experimental results indicated the feasibility of achieving 10-kV blocking, however, room for improvement to reduce static source-to-drain ON-resistance ${R}_{\text {DS},\text {ON}}$ and dynamic ${R}_{\text {DS},\text {ON}}$ degradation. A second generation (Gen. 2) SHJ-MOSFET was designed using an epitaxy with two 2DEG channels for larger ON-state drain current and smaller ${R}_{\text {DS},\text {ON}}$ . The high-voltage capability and dynamic ${R}_{\text {DS},\text {ON}}$ degradation mitigation were reached by implementing the GaN SHJ design, while simultaneously avoiding surface trapping between the gate and the SHJ structure. Gen. 2 experimentally showed scaling of blocking voltage with SHJ length up to 10 kV, reduced static ${R}_{\text {DS},\text {ON}}$ of $71.4~\Omega \cdot $ mm (73.5 $\text{m}\Omega \cdot $ cm $^{{2}}{)}$ , low ${R}_{\text {DS,ON}}{C}_{\mathrm {O(}\mathrm {tr})}$ of ~4.9 ps, and controlled current collapse of 123% when switched from an OFF-state bias of 3 kV.
29 March 2022 in IEEE Electron Device Letters
This letter reports the first controlled experimental study on the impact of charge-balance on static and dynamic characteristics of GaN super-heterojunction Schottky barrier diodes (SHJ-SBD). Charge balance between p- and n-type doped GaN for reducing peak E-field can be optimized via charge-balance etching (CBE) of the p-GaN SHJ region to improve dynamic ${R}_{\textit {ON}}$ degradation and breakdown voltage (BV). Three CBE conditions were fabricated with the same process on a single epitaxial wafer to mitigate process dependent variation. Charge-balance varied from donor-rich (thinner p-GaN) to near-optimum charge-balance condition, which enabled excellent dynamic ${R}_{\textit {ON}}$ degradation of 16.9% at 3 kV and BV greater than 10 kV without field plate. TCAD simulation reinforces understanding showing CBE effect on E-Field redistribution and reduced peak E-field.
30 May 2024 in IEEE Electron Device Letters
Monolithic integration of photodetector and transimpedance amplifier is demonstrated for galvanically isolated control of GaN power switches. The transimpedance amplifier includes a bootstrapping comparator and an optical receiver stage. The bootstrapping comparator features depletion-mode AlGaN/GaN high electron mobility transistors for optimized speed and input common mode range spanning from -1 to 8 V. The comparator delivers a voltage gain up to 176 V/V and a unity-gain bandwidth of 3.58 MHz. Within the optical receiver stage, the photodetector exhibits a photocurrent range of 50 to 100 nA when stimulated by a 340 nm wavelength light emitting diode. Together with a 330 kΩ pull-up resistor, the optical receiver stage generates a voltage signal ranging from 16.5 to 33 mV. The signal is then amplified by the bootstrapping comparator, resulting in an output voltage signal with a peak-to-peak voltage of 3.1 V, operating at 1 kHz frequency.
24 September 2024 in IEEE Transactions on Electron Devices
In gallium nitride (GaN) lateral power devices with advanced E-field management, isolation becomes a bottleneck for achieving higher breakdown voltage (BV). To understand the physical mechanism of isolation, the experimental analysis of isolation structures is done in this work. This article presents the measured leakage current and breakdown characteristics of isolation structures, compatible with lateral devices. For unimplanted isolation structures, leakage is injection barrier limited and breakdown is by surface punchthrough. BV has a quadratic dependence on the isolation length. Ion implantation introduces trap-limited hopping conduction, marked by the exponentially field-dependent conductance. After implantation, despite an increase in leakage current, BV increases drastically. The dependence of BV on isolation length changes from quadratic in unimplanted isolation to linear in implanted one due to flattening of E-field. To achieve high BV in GaN lateral power devices, the implanted isolation structure is preferred at the cost of high isolation leakage.
18 December 2024 in IEEE Transactions on Electron Devices
The superjunction (SJ), historically a silicon technology, has emerged as an effective method to increase blocking voltage with reduced on-resistance. A previous report of experimentally demonstrated lateral GaN super-heterojunction (SHJ) MOSFETs indicated potential for 10-kV-range low-loss and fast switching. The charging and discharging of p-type regions with holes utilized for creating a charge-balanced drift region may influence device switching time. In this work, a TCAD transient simulation study of an SHJ-FET is presented to understand: 1) the SHJ FET switching behavior and 2) how gate-to-drain spacing, hole mobility, acceptor ionization energy, and hole capture rate by p-type layer ionized acceptors influence switching time. It is revealed that device turn-on is driven by electrostatic potential in the p-GaN. A closed-form analytical model is derived to relate the turn-on time with key device and material parameters. Both TCAD simulation and the analytical model indicate that the turn-on time is in microsecond range for 10-kV-class devices.
1 May 2025 in APL Materials
Among GaN lateral power devices, with proper E-field management, the breakdown occurs in the device isolation region rather than the active region. In this paper, we investigate field-dependent carrier transport in the isolation structures. Isolation test structures with variations in buffer doping, un-intentionally doped (UID) GaN thickness, and implantation conditions were fabricated. Electrical characterization was performed over a wide range of voltage and temperature. With varying UID GaN thickness and buffer doping, the leakage current and breakdown characteristics remain the same for a specific implantation condition, indicating that the leakage conduction and breakdown are governed by the implanted GaN region. Analysis of the temperature-dependent I–V reveals that carrier transport in the implanted GaN can be well explained by hopping conduction, involving three distinctive regions of operation depending on the E-field. At low E-field, carrier transport is ohmic, consistent with variable range hopping, driven by thermal activation. At medium E-field, a field enhanced thermally activated hopping is observed, following σ ∼ σ(T)exp(E). At high E-field, activation-less hopping is visible, following σ ∼ exp(−1/E), which occurs above a critical E-field limited by localization length.