2 January 2024 in IEEE Transactions on Electron Devices
This article reports on two generations of GaN-on-sapphire super-heterojunction (SHJ) transistors, aiming at the realization of 10-kV class power transistors with low static and dynamic ON-resistance. First generation (Gen. 1) GaN SHJ-FETs used a single 2-D electron gas (2DEG) channel design with Schottky gate. Experimental results indicated the feasibility of achieving 10-kV blocking, however, room for improvement to reduce static source-to-drain ON-resistance ${R}_{\text {DS},\text {ON}}$ and dynamic ${R}_{\text {DS},\text {ON}}$ degradation. A second generation (Gen. 2) SHJ-MOSFET was designed using an epitaxy with two 2DEG channels for larger ON-state drain current and smaller ${R}_{\text {DS},\text {ON}}$ . The high-voltage capability and dynamic ${R}_{\text {DS},\text {ON}}$ degradation mitigation were reached by implementing the GaN SHJ design, while simultaneously avoiding surface trapping between the gate and the SHJ structure. Gen. 2 experimentally showed scaling of blocking voltage with SHJ length up to 10 kV, reduced static ${R}_{\text {DS},\text {ON}}$ of $71.4~\Omega \cdot $ mm (73.5 $\text{m}\Omega \cdot $ cm $^{{2}}{)}$ , low ${R}_{\text {DS,ON}}{C}_{\mathrm {O(}\mathrm {tr})}$ of ~4.9 ps, and controlled current collapse of 123% when switched from an OFF-state bias of 3 kV.
29 March 2022 in IEEE Electron Device Letters
This letter reports the first controlled experimental study on the impact of charge-balance on static and dynamic characteristics of GaN super-heterojunction Schottky barrier diodes (SHJ-SBD). Charge balance between p- and n-type doped GaN for reducing peak E-field can be optimized via charge-balance etching (CBE) of the p-GaN SHJ region to improve dynamic ${R}_{\textit {ON}}$ degradation and breakdown voltage (BV). Three CBE conditions were fabricated with the same process on a single epitaxial wafer to mitigate process dependent variation. Charge-balance varied from donor-rich (thinner p-GaN) to near-optimum charge-balance condition, which enabled excellent dynamic ${R}_{\textit {ON}}$ degradation of 16.9% at 3 kV and BV greater than 10 kV without field plate. TCAD simulation reinforces understanding showing CBE effect on E-Field redistribution and reduced peak E-field.
3 July 2025 in IEEE Electron Device Letters
A p-GaN gated high electron mobility transistor (HEMT) has been developed and electrically tested up to 800 ° C. The device demonstrated a high on-state current of 80 mA/mm and simultaneously a high ION/IOFF ratio of 770 at 800 ° C. The transistor was also thermally stressed at 800 ° C for 60 min. It demonstrated stable operation throughout the entire stress duration. The favorable on-current, on/off ratio, and stability show a promising path for high-temperature electronics based on GaN.
24 June 2025 in IEEE Electron Device Letters
A gallium nitride bootstrapping amplifier integrated circuit is demonstrated for high-temperature applications. The amplifier leverages bootstrapping gainboosting technology and incorporates five monolithically integrated depletion-mode gallium nitride high electron mobility transistors, enabling an operation temperature up to 800 °C in N2 environment. Those transistors feature a threshold voltage of approximately −2 V. Under a gate-to-source voltage of 5 V, the on-state current density decreased from 167 mA/mm at 25 °C to 45 mA/mm at 800 °C. At 25 °C, the amplifier exhibits a DC gain of 26.3 dB with a unity gain frequency of 8.9 MHz. At 800 °C, the amplifier delivers a DC gain of 31 dB and a unity gain frequency of 1.4 MHz. In addition, no significant degradation was observed after holding the transistor and amplifier unbiased for an hour at 800 °C. This amplifier integrated circuit demonstrates the competitiveness of gallium nitride high electron mobility transistors as a promising technology for high-temperature electronics, up to 800 °C.
30 May 2024 in IEEE Electron Device Letters
Monolithic integration of photodetector and transimpedance amplifier is demonstrated for galvanically isolated control of GaN power switches. The transimpedance amplifier includes a bootstrapping comparator and an optical receiver stage. The bootstrapping comparator features depletion-mode AlGaN/GaN high electron mobility transistors for optimized speed and input common mode range spanning from -1 to 8 V. The comparator delivers a voltage gain up to 176 V/V and a unity-gain bandwidth of 3.58 MHz. Within the optical receiver stage, the photodetector exhibits a photocurrent range of 50 to 100 nA when stimulated by a 340 nm wavelength light emitting diode. Together with a 330 kΩ pull-up resistor, the optical receiver stage generates a voltage signal ranging from 16.5 to 33 mV. The signal is then amplified by the bootstrapping comparator, resulting in an output voltage signal with a peak-to-peak voltage of 3.1 V, operating at 1 kHz frequency.
24 September 2024 in IEEE Transactions on Electron Devices
In gallium nitride (GaN) lateral power devices with advanced E-field management, isolation becomes a bottleneck for achieving higher breakdown voltage (BV). To understand the physical mechanism of isolation, the experimental analysis of isolation structures is done in this work. This article presents the measured leakage current and breakdown characteristics of isolation structures, compatible with lateral devices. For unimplanted isolation structures, leakage is injection barrier limited and breakdown is by surface punchthrough. BV has a quadratic dependence on the isolation length. Ion implantation introduces trap-limited hopping conduction, marked by the exponentially field-dependent conductance. After implantation, despite an increase in leakage current, BV increases drastically. The dependence of BV on isolation length changes from quadratic in unimplanted isolation to linear in implanted one due to flattening of E-field. To achieve high BV in GaN lateral power devices, the implanted isolation structure is preferred at the cost of high isolation leakage.