Jianlin Xia

Mr. Jianlin Xia


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 September 2026 in Electronics
Verified
Journal Article
Open access
PDF file
YLYongjia Li
Yongjia Li
YLYi Liu
Yi Liu
YCYifan Cao
Yifan Cao
YLYuanqin Lu
Yuanqin Lu
JXJianlin Xia
Jianlin Xia
WSWeifeng Sun
Weifeng Sun
This work presents an incremental zoom analog-to-digital converter (ADC) readout integrated circuit (IC) and field-programmable gate array (FPGA)-based digital calibration system for high-precision capacitive micro electro-mechanical system (MEMS) pressure sensors, aimed at enhancing pressure readout resolution, pressure measurement accuracy, and long-term output stability. In the readout IC, the zoom ADC employs coarse-fine quantization, achieving high readout accuracy while relaxing requirements on integrator output swing and front-end linearity. On the digital side, a sparrow-search-algorithm-optimized Gaussian process regression (SSA-GPR) model constructs a nonlinear pressure–temperature mapping with limited calibration samples, while a segmented aging-compensation scheme based on dual-channel periodic self-test dynamically corrects aging-induced offset and sensitivity drifts. Together, these three techniques form a complete signal-conditioning chain addressing weak capacitance variation readout, pressure–temperature coupling, and long-term drift. Measured results show 0.11 PaRMS output root mean square (RMS) noise under a 205.2 ms conversion time, 37.44 Pa mean absolute error over −40 °C to 85 °C and 30 kPa to 120 kPa, and ±30 Pa residual error after 85 °C/1000 h aging, confirming the effectiveness of the proposed readout IC and digital calibration system.

25 February 2025 in Electronics
Verified
Journal Article
Open access
PDF file
YLYongjia Li
Yongjia Li
JXJianlin Xia
Jianlin Xia
SXShen Xu
Shen Xu
EZEncheng Zhu
Encheng Zhu
WSWeifeng Sun
Weifeng Sun
This paper proposes a transient energy auxiliary supply circuit architecture based on resonant switched-capacitor principles, aimed at optimizing the system’s transient response to meet the growing power supply demands. This paper first introduces the relevant principles of resonant switched-capacitor converters. Based on this, a transient energy path topology based on resonant principles is designed to achieve bidirectional, fast, and low electromagnetic interference energy transmission. Corresponding system coordination control strategies and high-precision switch control based on delay lines are proposed for the designed circuit topology. A circuit model is built in SIMPLIS (V8.20a) software for system simulation, and a prototype is built based on FPGA to verify circuit functionality and performance. Experimental results demonstrate that the resonant energy auxiliary circuit can operate in conjunction with a six-phase Buck circuit prototype. Under test conditions of a 500 kHz operating frequency, 6.5 V input voltage, and 0.75 V output voltage, the overshoot voltage is reduced by more than 17% across the entire operating range. When the load steps from 200 A to 20 A, the overshoot voltage is reduced to only 85 mV, a decrease of 27.97%, while the recovery time is 28.8 µs, a reduction of 37.66%. These results confirm that the auxiliary circuit can significantly improve the system’s transient response under large load steps, meeting the design requirements.