This study conducted a systematic investigation on how Ca content affected Mg-6Al-1Sn alloys as anodes for Mg-air batteries in terms of their microstructure, electrochemical corrosion behavior, and discharge performance. According to the investigation results, incorporating Ca induces the formation of blocky β-Mg17Al12 phases containing Ca and refines the grain structure. Compared to Mg alloys without Ca, the alloys with Ca exhibit significantly improved self-corrosion resistance because the preferential enrichment of Ca at the grain boundaries within β-Mg17Al12 phases reduces the potential difference between β-Mg17Al12 phases and Mg matrix. Consequently, galvanic corrosion is mitigated, together with the effective suppression of the self-corrosion reaction of Mg anodes. Additionally, Mg alloy shows a higher anode utilization efficiency with Ca content. The combined results indicate that Mg-6Al-1Sn-0.5Ca alloy exhibits superior self-corrosion resistance and discharge properties vs. other tested compositions. Furthermore, the Mg-air battery using Mg-6Al-1Sn-0.5Ca alloy as the anode demonstrates a heavier average discharge potential and a utilization efficiency of 71.12%, which is 7.56% higher than Mg-6Al-1Sn alloy.
In this study, machine hammer peening (MHP) was employed to enhance the surface properties of CuSn12 alloys, and the effects of different impact energies on the surface morphology, mechanical properties, and electrochemical properties were systematically investigated. The results revealed that the surface morphology evolution after MHP treatment exhibited unique non-monotonic characteristics, which significantly differed from the surface effects of conventional shot peening technology. Microhardness tests indicated that the surface hardness increased by 40% to approximately 150 HV after treatment with 3.5 J impact energy. Friction and wear tests demonstrated that specimens treated with 2.7 J impact energy exhibited optimal wear resistance, with an 82.7% reduction in volume wear loss, and the wear mechanism transformed from composite wear to mild fatigue wear. Electrochemical performance tests showed that corrosion resistance continuously improved as the impact energy increased from 2.7 J to 3.5 J, primarily attributed to grain refinement and passive film formation; however, treatment with 1.7 J impact energy resulted in decreased corrosion resistance. The results demonstrate that optimizing MHP process parameters can significantly enhance the overall properties of CuSn12 alloys, providing a novel technical approach for the surface-strengthening of this alloy.