The global coronavirus (COVID-19) pandemic in early 2020 caused the amount of medical waste, especially plastic waste, to increase. The pandemic exacerbated the plastic waste management problem, including the need to find more sustainable treatment methods. This study investigated the sustainable conversion of plastic waste (FFP2-type face masks) to syngas via pure CO2 plasma gasification to recover energy and reduce environmental pollution. A direct current (DC) thermal arc plasma torch of 40.6–68.4 kW power generated the plasma stream. Carbon dioxide (CO2), as a greenhouse gas (GHG), was used as the main plasma-forming gas and gasifying agent. The 140thermal feedstock input plasma gasification system was used in the study. The effect of the CO2-to-C ratio on the gasification performance efficiency was investigated. The best CO2 plasma gasification process performance was obtained at a CO2-to-C ratio of 2.34. In these conditions, the main syngas components (H2 + CO) comprised 80.46 vol.% (H2: 24.62 vol.% and CO: 55.84 vol.%) and the following values were seen for the heating value of the syngas (LHVsyngas: 13.88 MJ/Nm3), the syngas yield (3.13 Nm3/kgFFP2), the tar content in the syngas (23.0 g/Nm3), the carbon conversion efficiency (CCE: 70.6%), and the cold gas efficiency (CGE: 47.8%). Additionally, the plasma gasification process mass and energy balance were evaluated. It was demonstrated that CO2 plasma gasification could be a promising thermochemical treatment technology for sustainable plastic waste disposal and the simultaneous utilization of greenhouse gases, such as carbon dioxide.
20 July 2025 in International Journal of Hydrogen Energy
A control-oriented model about PEM fuel cell system with anodic and cathodic exhaust gas recirculation is introduced in this paper. It contains anode and cathode system model, fuel cell stack model which contains water transport model, oxygen transport model, nitrogen transport model, voltage model and stack cooling system model. Only the water transport model is introduced here. Then the model is verified by experiment. Results show a good agreement between the simulated and measured cell voltages, cathode inlet molar water concentrations.