An improved structure for axial-flux eddy current couplings with combined rectangle-shaped magnets is proposed to minimize cogging torque without sacrificing torque density. Then, a novel analytical electromagnetic-thermal model, which takes the change of material electromagnetic and thermal characteristics under temperature, is presented to calculate cogging torque, electromagnetic torque, eddy current loss and temperature. The model is valid for the whole working area. The magnetic field distribution is calculated by the quasi 3-D electromagnetic field analytical model. Then cogging torque, electromagnetic torque and eddy current loss can be obtained. Furthermore, an equivalent thermal resistance network model is established. The thermal model takes the previously obtained eddy current losses as the heat source, which is the eddy current loss of copper and copper back iron. With the help of the electromagnetic-thermal model, the characteristics of slip on electromagnetic torque, eddy current loss, copper and permanent magnet temperature rise is also analyzed under the whole working range. The validity of the electromagnetic–thermal model is confirmed with finite element method (FEM) and measurement.
Traveling-wave-based fault location methods are widely used for modern power systems owing to their high accuracy on two-terminal lines. However, they perform poorly on hybrid multi-terminal lines. Many traveling-wave-based methods have been developed recently to solve this problem, but they have high computational burdens and complex fault location procedures. To tackle this challenge, a new fault location method is presented in this paper. First, to ensure that the implementation of the proposed method is not affected by different line parameters, a normalization algorithm is used for hybrid multi-terminal lines, which consist of overhead lines and cables. To reduce the complexity, a novel fault section identification method that depends only on the first three arrival times is applied to separate a three-terminal fault section from the multi-terminal lines. Consequently, the fault can be located using a corresponding two-terminal fault location method in this fault section. To verify its effectiveness, fault case studies and performance evaluations are performed in the PSCAD and MATLAB/Simulink environment. The simulation results reveal that the proposed method can correctly identify the fault section and accurately locate the faults, which is simple and suitable for hybrid multi-terminal lines.
13 February 2018 in IEEE Transactions on Magnetics
A new analytical model of axial-flux eddy current device is proposed in this paper, which is based on the equivalent circuit model. In order to simplify analysis, linearization at the mean radius is assumed in the 3-D model of eddy current device. In the equivalent circuit model, copper plate can be seen as a sum of coils in different volume elements. The equivalent circuit of coil is characterized by induced voltage, resistance, and inductance, which are calculated with the electromotive force, reaction flux, and linkage current in the copper plate frame of reference. To obtain these field solutions, the 3-D analytical computation method is employed to solve the Maxwell equations in Cartesian coordinate. The flux linkage equation, voltage equation, and torque equation are set up to depict the reaction field produced by eddy current and the function between the torque and slip speed in steady-state condition. With the equivalent resistance and inductance, the expression of torque becomes much simpler, and the inverse of which can also be obtained. Then, magnetic flux density, torque, and slip speed calculated by the proposed analytical model are compared with the 3-D analytical model and 3-D finite-element method.
A new approach to study the steady-state and transient performances of an axial-flux eddy current coupler is presented in this paper. To simplify the analysis, the 3-D model of the eddy current coupler is reduced to a 3-D linear model using the mean radius assumption. The equivalent circuit model of the eddy current coupler is employed, and the flux linkage equation, voltage equation, and torque equation are developed. In the 3-D Cartesian coordinates, the equivalent circuit parameters are calculated, and the steady-state and transient torque formulas are obtained by solving the flux linkage equation and voltage equation in steady-state and transient condition respectively, and then, the torque formulas are used to study the performances of the eddy current coupler. In order to show the effectiveness of the proposed performance analysis method, the steady-state and transient performances of an axial-flux eddy current coupler prototype are investigated, and the analytical calculation results are compared with the 3-D finite element method simulations and experimental tests.