Demand trends towards mass customization drive the need for increasingly productive and flexible assembly operations. Walking-worker assembly lines can present advantages over fixed-worker systems. This article presents a multiproduct parallel walking-worker assembly line with shared automated stations, and evaluates its operational performance compared to semiautomated and manual fixed-worker lines. Simulation models were used to set up increasingly challenging scenarios based on an industrial case study. The results revealed that semiautomated parallel walking-worker lines could achieve greater productivity (+30%) than fixed-worker lines under high-mix low-volume demand conditions.
In many cases, the design process of a structural ceramic comminution plant typically consists of an ‘expert designer’ who makes decisions using intuitive criteria to select commercial equipment. This paper proposes a simulationbased optimization approach to help decisionmaking. The complexity of the problem lies in selecting the model and amount of equipment for each stage at the lowest cost while simultaneously satisfying a previously fixed production and granulometry. The proposed approach is based on a genetic algorithm to generate solutions and facilitate the optimization process, together with discrete simulation to evaluate the performance of the comminution process according to its service level. To evaluate the algorithm, different problems, whose parameters are based on the requirements of the ceramic industry, are solved and analyzed.
Surface topography plays a critical role in the functional performance of machined freeform components, yet its assessment traditionally takes place only after manufacturing. This work presents a simulation-assisted framework for predicting the surface topography generated during freeform ball-end milling and using these predictions to support machining-strategy selection. Three finishing strategies (3-axis square, SQ3, 3-axis spiral, SP3, and 5-axis spiral, SP5) were investigated on a representative freeform benchmark by combining high-resolution UVRMAP simulations with experimental topography measurements. Surface signatures were characterized using ISO 25178 areal parameters together with two- and one-dimensional Fast Fourier Transform (FFT) analyses, enabling quantitative evaluation of surface amplitude, preferential orientations, anisotropy, and characteristic spatial periodicities. The results demonstrate that machining strategy and local surface geometry produce distinctive topographical signatures that cannot be fully described by conventional roughness parameters alone.Theproposed UVRMAP methodology accurately reproduces the primary spatial organization of the geometric texture generated by the programmed toolpath, while the incorporation of a controlled non-ideal cutter-edge representation improves the prediction of experimentally observed fine-scale features. The combined experimental–simulation methodology provides a robust framework for comparing and validating the spatial and morphological characteristics of predicted surface topographies, providing a basis for future machining-strategy selection according to application-specific surface requirements.