Water scarcity and water pollution have become increasingly severe, and therefore, the purification of water resources has recently garnered increasing attention. Given its position as a major water resource, the efficient purification of drinking water is of crucial importance. In this study, we adopted a phase transition method to prepare ZrO2/BCM (bamboo cellulose membranes), after which we developed IP-ZrO2/BC-NFM (bamboo cellulose nanofiltration membranes) through interfacial polymerization using piperazine (PIP) and tricarbonyl chloride (TMC). Subsequently, we integrated these two membranes to create a combined “ultrafiltration + nanofiltration” membrane process for the treatment of drinking water. The membrane combination process was conducted at 25 °C, with ultrafiltration at 0.1 MPa and nanofiltration at 0.5 MPa. This membrane combination, featuring “ultrafiltration + nanofiltration,” had a significant impact on reducing turbidity, consistently maintaining the post-filtration turbidity of drinking water at or below 0.1 NTU. Furthermore, the removal rates for CODMN and ammonia nitrogen reached 75% and 88.6%, respectively, aligning with the standards for high-quality drinking water. In a continuous 3 h experiment, the nanofiltration unit exhibited consistent retention rates for Na2SO4 and bovine serum protein (BSA), with variations of less than 5%, indicating exceptional separation performance. After 9 h of operation, the water flux of the nanofiltration unit began to stabilize, with a decrease rate of approximately 25%, demonstrating that the “ultrafiltration + nanofiltration” membrane combination can maintain consistent performance during extended use. In conclusion, the “ultrafiltration + nanofiltration” membrane combination exhibited remarkable performance in the treatment of drinking water, offering a viable solution to address issues related to water scarcity and water pollution.
2-Methyltetrahydrofuran (2-MTHF), a hydrogenated derivative of levulinic acid (LA), is a biomass-derived platform compound with diverse and significant applications as a biofuel, gasoline additive, green solvent, and pharmaceutical synthesis intermediate. This study investigates the preparation of a Cu1Ni2/Al2O3 catalyst through the calcination–reduction of CuNiAl hydrotalcite as a precursor, which was subsequently utilized in the hydrogenation of LA to produce 2-MTHF. The calcination–reduction process applied to CuNiAl hydrotalcite results in a lattice confinement effect. This method not only disperses the active metal sites but also alters the bonding patterns of the active metals, thereby enhancing the activity and stability of the Cu1Ni2/Al2O3 catalyst. The results indicate that complete conversion of LA and a 2-MTHF yield of 87.6% can be achieved under optimal conditions of 190 °C, 5 MPa hydrogen, and a reaction time of 5 h, demonstrating an efficient one-step conversion process. Additionally, the catalyst’s recyclability was assessed through multiple reuse tests, with a loss of activity of only 9.2% after six cycle experiments, suggesting its feasibility and reliability for industrial applications.