Water scarcity and water pollution have become increasingly severe, and therefore, the purification of water resources has recently garnered increasing attention. Given its position as a major water resource, the efficient purification of drinking water is of crucial importance. In this study, we adopted a phase transition method to prepare ZrO2/BCM (bamboo cellulose membranes), after which we developed IP-ZrO2/BC-NFM (bamboo cellulose nanofiltration membranes) through interfacial polymerization using piperazine (PIP) and tricarbonyl chloride (TMC). Subsequently, we integrated these two membranes to create a combined “ultrafiltration + nanofiltration” membrane process for the treatment of drinking water. The membrane combination process was conducted at 25 °C, with ultrafiltration at 0.1 MPa and nanofiltration at 0.5 MPa. This membrane combination, featuring “ultrafiltration + nanofiltration,” had a significant impact on reducing turbidity, consistently maintaining the post-filtration turbidity of drinking water at or below 0.1 NTU. Furthermore, the removal rates for CODMN and ammonia nitrogen reached 75% and 88.6%, respectively, aligning with the standards for high-quality drinking water. In a continuous 3 h experiment, the nanofiltration unit exhibited consistent retention rates for Na2SO4 and bovine serum protein (BSA), with variations of less than 5%, indicating exceptional separation performance. After 9 h of operation, the water flux of the nanofiltration unit began to stabilize, with a decrease rate of approximately 25%, demonstrating that the “ultrafiltration + nanofiltration” membrane combination can maintain consistent performance during extended use. In conclusion, the “ultrafiltration + nanofiltration” membrane combination exhibited remarkable performance in the treatment of drinking water, offering a viable solution to address issues related to water scarcity and water pollution.
γ-Valerolactone (GVL) is a promising bio-based platform molecule with significant potential for energy applications. The production of GVL via biomass-based levulinic acid (LA) is an important reaction. To enhance the conversion and selectivity of non-precious-metal catalysts in the LA-to-GVL process and to better understand the key factors influencing this conversion, we conducted a series of experiments. In this study, supported Cu-Ni bimetallic catalysts (Cu-Ni2/Al2O3) were prepared using layered double hydroxides (LDHs) as a precursor. Compared with Cu-Ni catalysts synthesized via the conventional impregnation method, the Cu-Ni2/Al2O3 catalysts exhibit higher catalytic activity and stability. The results demonstrated that efficient conversion was achieved with isopropanol as the hydrogen donor solvent, a reaction temperature of 180 °C, and a reaction time of 1 h. The yield of GVL reached nearly 90%, with a decrease of approximately only 6% after six consecutive cycles. The Cu-Ni2/Al2O3 catalyst proved to be effective for converting biomass-derived LA to GVL, offering a route that not only reduces production costs and environmental impact but also enables efficient biomass-to-energy conversion.