The TerraSAR-X mission, based on two satellites, has produced SAR data products of high quality for a number of scientific and commercial applications for more than ten years. To guarantee the stability and the reliability of these highly accurate SAR data products, both systems were first accurately calibrated during their respective commissioning phases and have been permanently monitored since then. Based on a short description of the methods applied, this paper focuses on the radiometric performance including the gain and phase properties of the transmit/receiver modules, the antenna pattern checked by evaluating scenes acquired over uniformly distributed targets and the radiometric stability derived from permanently deployed point targets. The outcome demonstrates the remarkable performance of both systems since their respective launch.
A synthetic aperture radar (SAR) system requires external absolute calibration so that radiometric measurements can be exploited in numerous scientific and commercial applications. Besides estimating a calibration factor, metrological standards also demand the derivation of a respective calibration uncertainty. This uncertainty is currently not systematically determined. Here for the first time it is proposed to use hierarchical modeling and Bayesian statistics as a consistent method for handling and analyzing the hierarchical data typically acquired during external calibration campaigns. Through the use of Markov chain Monte Carlo simulations, a joint posterior probability can be conveniently derived from measurement data despite the necessary grouping of data samples. The applicability of the method is demonstrated through a case study: The radar reflectivity of DLR’s new C-band Kalibri transponder is derived through a series of RADARSAT-2 acquisitions and a comparison with reference point targets (corner reflectors). The systematic derivation of calibration uncertainties is seen as an important step toward traceable radiometric calibration of synthetic aperture radars.
Active Radar Calibrators (ARC), also called calibration transponders, are often used as reference targets for absolute radiometric calibration of radar systems due to their large achievable Radar Cross-Section (RCS). However, before using a transponder as a reference target, the hardware itself has to be calibrated. A novel method, called the three-transponder method, was proposed some years ago and allows for RCS calibration of digital transponders without using any RCS targets as reference. In this paper, this technique is further refined and applied to a setup utilizing only one digital transponder. The accurate measurement design is described and a novel, elaborated data processing scheme is developed to minimize remaining noise and clutter effects in the data. A comprehensive error analysis is presented in the second part of this paper.
Active radar calibrators (ARCs), also known as calibration transponders, are often used as reference targets for the absolute radiometric calibration of radar systems due to their large radar cross-sections (RCSs). Before such a transponder can be used as a reference target, the hardware itself has to be calibrated. A novel method, called the three-transponder method, was proposed some years ago to allow for RCS calibration of digital transponders without using any known RCS targets as reference. The first part of this paper refines the technique and presents the measurement setup as well as the results of a comprehensive measurement campaign performed to calibrate a single digital transponder. In this part of the paper, the results are validated and a comprehensive uncertainty analysis is performed to estimate the total RCS uncertainty associated with the presented measurement data. This uncertainty analysis follows the international standard “Guide to the expression of uncertainty in measurement” (GUM) and will derive expressions for all major sources of uncertainty. For the validation, the measurement results will be compared with full-wave electromagnetic simulations of trihedral corner reflectors; there is excellent agreement between the simulation and measurements.