Serkan Abbasoglu

Dr. Serkan Abbasoglu

orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 May 2018 in Sustainability
Verified
Journal Article
Open access
PDF file
EAErdoğan Arıkan
Erdoğan Arıkan
SASerkan Abbasoglu
Serkan Abbasoglu
MGMustafa Gazi
Mustafa Gazi
In this study, the effect of Al2O3-water and ZnO-water nanofluids, with and without ethylene glycol (EG), on the efficiency of a flat plate solar collector was investigated. Two systems were set up and the nanofluids with and without EG were examined at the same time. The volume fraction of the nanoparticles and EG were 0.25% and 25%, respectively. The study was conducted on three mass flow rates: 0.05 kg/s, 0.07 kg/s, and 0.09 kg/s. ASHRAE Standard 93-2010 was used to calculate the efficiency. The efficiency of the system was compared to distilled water (base fluid). The results also showed that an increase in the mass flow rate and use of the EG increased efficiency. Furthermore, in comparison with the base fluid, the maximum increase in efficiency (15.13%) was observed at 0.09 kg/s when using a Al2O3-water/EG nanofluid.

28 April 2022 in Processes
Verified
Journal Article
Open access
PDF file
TRTonderai Linah Ruwa
Tonderai Linah Ruwa
SASerkan Abbasoglu
Serkan Abbasoglu
MAMustafa Ertan Akün
Mustafa Ertan Akün
Despite the research that has been conducted on biogas production from different waste materials through the anaerobic digestion process, there are still limited studies on their application for thermal systems. This paper presents an energetic and exergetic analysis of a multigeneration system comprising a micro-gas turbine, an organic Rankine cycle (ORC), an absorption chiller, and a water heater. It uses energy from biogas combustion produced through anaerobic co-digestion of food and animal waste. The reported biogas yield from 3 different studies was used in designing the fuel input for the system. The results showed that substrate combination of poultry manure and food waste (Biogas-A) needs 35.07 tons of volatile solids (tons-VS/day) of waste compared to 33.11 tons-VS/day for Biogas-B (Cattle manure and food waste), and 81.87 tons-VS/day for Biogas-C (swine manure and corn straw). For an increase in the methane content from 40% to 60%, the substrate amounts were reduced by 42.3% for Biogas-A, 45.3% for Biogas-B, and 42.7% for Biogas-C. Likewise, for an increase in recuperator effectiveness from 65% to 95%, the substrate amounts reduced by 31.6% for Biogas-A, 30.3% for Biogas-B, and 31.4% for Biogas-C. Increasing the ambient temperature was shown to have an adverse effect on the performance of the system. The energy efficiency of the system reduced from 47.8% to 39.8% and the exergy efficiency reduced from 63% to 60% for an increase from 5 °C to 40 °C. The total exergy destruction of the system also increased from 1760 kW to 1885 kW. The results from this study will give an overview for future practical design for electricity production from waste and the choice of biomass materials to be utilized.

14 November 2018 in Journal of Solar Energy Engineering
Verified
Journal Article
Closed access
PDF file
EOERIC OKONKWO
ERIC OKONKWO
MAMUHAMMAD ABID
MUHAMMAD ABID
Tahir Abdul Hussain RatlamwalaTahir Abdul Hussain Ratlamwala
Tahir Abdul Hussain Ratlamwala
SASerkan Abbasoglu
Serkan Abbasoglu
Mustafa DagbasiMustafa Dagbasi
Mustafa Dagbasi
This study presents an experimental nanoparticle synthesis and the numerical analysis of a parabolic trough collector (PTC) operating with olive leaf synthesized TiO2/water nanofluid. The PTC is modeled after the LS-2 collector for various operating conditions. An analysis of the heat transfer and entropy generation in the PTC is carried out based on the first and second laws of thermodynamics for various parameters of nanoparticle volumetric concentration (0 ≤ φ ≤ 8%), mass flow rate (0.1 ≤ m˙ ≤ 1.1 kg/s), and inlet temperatures (350–450 K) under turbulent flow regime. The effect of these parameters is evaluated on the Nusselt number, thermal losses, heat convection coefficient, outlet temperature, pressure drop, entropy generation rate, and Bejan number. The results show that the values of the Nusselt number decrease with higher concentrations of the nanoparticles. Also, the addition of nanoparticles increases the heat convection coefficient of the nanofluid compared to water. The thermal efficiency of the system is improved with the use of the new nanofluid by 0.27% at flow rates of 0.1 kg/s. The entropy generation study shows that increasing the concentration of nanoparticles considerably decreases the rate of entropy generation in the system. It is also observed that increasing the volumetric concentration of nanoparticles at low mass flow rates has minimal effect on the rate of entropy generation. Finally, a correlation that provides a value of mass flow rate that minimizes the entropy generation rate is also presented for each values of inlet temperature and nanoparticle volumetric concentration.

1 January 2015 in Turkish Journal of Electrical Engineering and Computer Sciences
Verified
Journal Article
Closed access
ABAkinola Adeyinka Babatunde
Akinola Adeyinka Babatunde
SASerkan Abbasoglu
Serkan Abbasoglu

30 June 2022 in Journal of Energy Systems
Verified
Journal Article
Open access
PDF file
NRNabaz Mohammedalı RASOOL
Nabaz Mohammedalı RASOOL
SASerkan Abbasoglu
Serkan Abbasoglu
MRMEHRSHAD RADMEHR
MEHRSHAD RADMEHR
As an effective means of providing power to remote and off-grid areas of developing countries, where rural electrification problems are most common, hybrid renewable energy systems are considered. HOMER simulated and configured wind turbine, photovoltaic, battery bank, and converter for the electricity demand of the Mander rural community, which has 37 families with household sizes of 7 members, as a remote village in Northern Iraq in this article. The hypothesis project was also evaluated using the parameters Net Present Value and Simple Payback Period. Daily energy consumption of 173,120 kWh and peak electricity consumption of 32,14 kW were measured for the outcome of the selected site. The proposed system produced 68,458 kWh/yr (13.7 percent) by the wind turbine, PV created 432,354 kWh/yr. (86.3 percent), and 265 operating batteries with a total operating cost (TOC) and costs of energy (COE) of $9,195 and 0.365 $/kWh, respectively. This survey emphasized the role of solar photovoltaic and wind turbine as hybrid renewable energy systems HRESs in the sustainable supply of electricity in rural areas of northern Iraq.

25 July 2022 in Sustainability
Verified
Journal Article
Open access
PDF file
TKTurgut Karahüseyin
Turgut Karahüseyin
SASerkan Abbasoglu
Serkan Abbasoglu
Evolution from fossil fuel sources to environmentally friendly and sustainable energy sources is one of the key aspects of the energy transition goal. On the other hand, Solar Photovoltaic systems are the most promising and improving technologies in the energy market However, it is well known that the performance of PV panels decreases in the process of time. This paper focuses on analyzing the performance loss rates (PLR) of mid-scale crystalline silicon (c-Si) PV systems of the same manufacturer with different orientations and tilt angles in the same region for the duration of four years of outdoor exposure. Three commonly used statistical methods are deployed to calculate PLRs; seasonal and trend decomposition using locally weighted scatterplot smoothing (STL), classical seasonal decomposition (CSD) and year on year (YoY) methods coupled with various performance metrics, namely Performance ratio (PR), temperature corrected performance ratio TCPR) and weather corrected performance ratio suggested by National Renewable Energy Laboratory (NRELPR). It is found that PLRs of analyzed venues, Arazi, Arena and Stonite, with the YOY approach are −1.2%/year, −0.73%/year and −2.65%/year, respectivelty., respectively. Furthermore, STL method demonstrated PLRs of −0.69%/year, −0.65%/year and −2.91%/year, respectively. On the other hand, the CSD method generated positive PLRs for some inverters while aforementioned statistical approaches proposed PLRs close to −2%/year, making the CSD method inappropriate for use under a heavy soiling environment. Within two km distance, variations up-to four-fold in PLRs are recorded between the venues during analyzed period. Furthermore, variations in PLRs are more dependent on the statistical approach rather than the performance metric.