This paper presents the use of a novel approach in assessing the generation reliability of a hybrid mini-grid system (HMS) based on the optimal design result obtained from the HOMER software. A typical Nigerian rural community - Lade II in Kwara State was used as a case study where the energy demand for the residential and commercial loads was 2.5MWh/day and 171kWh/day respectively. The optimized HMS results from HOMER comprising of a solar photovoltaic (PV) array (1.5MW), diesel generators (350kW) and battery storage (1200 units) has a combined least net present cost of $4,909,206 and a levelized electricity tariff of $0.396 per kWh. Contrasting the HMS with a diesel-only system for the community, an approximate 97% reduction in all pollutant emissions was observed. Furthermore, fluctuations in diesel fuel prices, variations in average solar insolation, and variations in the solar PV's capital/replacement costs were utilized in conducting a sensitivity analysis for the HMS. The capacity outage probability table (COPT) was utilized in validating the reliability of the simulation results obtained from HOMER. The HMS was observed to experience a load loss of 0.769MW, 0.594MW & 0.419MW when zero, one and two diesel generator(s) respectively were operational for all of the Solar PV's and Batteries being off-line. The loss of load probability (LOLP), loss of load expectation (LOLE), and total expected load loss (ELL) obtained from the COPT were 5.76 × 10-8, 5.0457 × 10-4 hr/yr and 0.025344Watt respectively. The results show the reliability of the HMS and also depicts a highly economical and feasible hybrid energy system.
1 October 2023 in International Journal of Electrical and Computer Engineering (IJECE)
The global transition from fossil-based automobile systems to their electric-driven counterparts has made the use of a storage device inevitable. Owing to its high energy density, lower self-discharge, and higher cycle lifetime the lithium-ion battery is of significant consideration and usage in electric vehicles. Nevertheless, the state of charge (SOC) of the battery, which cannot be measured directly, must be calculated using an estimator. This paper proposes, by means of a modified priori estimate and a compensating proportional gain, an improved extended Kalman filter (IEKF) for the estimation task due to its nonlinear application and adaptiveness to noise. The improvement was achieved by incorporating the residuals of the previous state matrices to the current state predictor and introducing an attenuating factor in the Kalman gain, which was chosen to counteract the effect of the measurement and process noise resulting in better accuracy performance than the conventional SOC curve fitting-based estimation and ampere hour methods. Simulation results show that the standard EKF estimator results in performance with an error bound of 12.9% due to an unstable start, while the modified EKF reduces the maximum error to within 2.05% demonstrating the quality of the estimator.
With the proliferation of non-linear loads in electricity supply industry, interests in improving quality of electrical supply have increased significantly. Power quality challenges have generated disputes between customers, network operators and equipment manufacturers globally. Identification of the sources of harmonics, and the quantification of the identified variables at the points of common coupling (PCC) pose challenges in the electricity supply industry. Critical in the determination of the harmonic contributions are data for harmonic distortions in phase currents and voltages, power factor, apparent power, active power, reactive power, and frequency. The data were obtained at the PCC between 5 different arc furnace steel plant and the transmission network. The data were captured at 33kV and 132kV voltage level at the steel plant PCC using a Circuitor AR6 power analyser connected through incoming voltage transformers (VTs) and current transformers (CTs). Histograms and cumulative probability distribution plots present the harmonic contents of the data. This data can be reused for artificial intelligence and machine learning application in real-time monitoring of state of health at the PCC and design of filter networks to mitigate harmonics.
23 January 2020 in International Journal of Energy Economics and Policy
The use of batteries for diverse energy storage applications is increasing, primarily because of their high energy density, and lithium-ion batteries (LiBs) are of particular significance in this regard. However, designing estimators that are robust to compute the state of charge (SOC) of these batteries in the presence of disturbance signals arising from different battery types remains a challenge. Hence, this paper presents a hybrid estimator that combines the extended Kalman filter (EKF) and sliding mode observer (SMO) via a switching function and tracking closed loop to achieve the qualities of noise cancellation and disturbance rejection. Hybridization was carried out in such a way that the inactive observer tracks the output of the used observer, simultaneously feeding back a zero-sum signal to the input gain of the used observer. The results obtained show that noise filtering is preserved at a convergence time of .01 s. Also, the state of charge estimation interval improves greatly from a range of [1, .93] and [.94, .84] obtained from the extended Kalman filter and sliding mode observer, respectively, to a range of [1, 0], in spite of the added disturbance signals from a lithium–nickel (INR 18650) battery type.
23 September 2024 in Information Dynamics and Applications
The classification of fruit ripeness and detection of defects are critical processes in the agricultural industry to minimize losses during commercialization. This study evaluated the performance of three Convolutional Neural Network (CNN) architectures—Extreme Inception Network (XceptionNet), Wide Residual Network (Wide ResNet), and Inception Version 4 (Inception V4)—in predicting the ripeness and quality of tomatoes. A dataset comprising 2,589 images of beef tomatoes was assembled from Golden Fingers Farms and Ranches Limited, Abuja, Nigeria. The samples were categorized into six classes representing five progressive ripening stages and a defect class, based on the United States Department of Agriculture (USDA) colour chart. To enhance the dataset's size and diversity, image augmentation through geometric transformations was employed, increasing the dataset to 3,000 images. Fivefold cross-validation was conducted to ensure a robust evaluation of the models' performance. The Wide ResNet model demonstrated superior performance, achieving an average accuracy of 97.87%, surpassing the 96.85% and 96.23% achieved by XceptionNet and Inception V4, respectively. These findings underscore the potential of Wide ResNet as an effective tool for accurately detecting ripeness levels and defects in tomatoes. The comparative analysis highlights the effectiveness of deep learning (DL) techniques in addressing challenges in agricultural automation and quality assessment. The proposed methodology offers a scalable solution for implementing automated ripeness and defect detection systems, with significant implications for reducing waste and improving supply chain efficiency.