This study evaluated the effect of various adhesive systems, particularly silane application, on the repair bond strength of a nanofill resin composite and associated stress distribution using finite element analysis (FEA). A total of 105 composite specimens (4 × 6 mm) were aged by thermal cycling (10,000 cycles), roughened, etched with phosphoric acid, and assigned to seven groups (n = 15): G1. control—no adhesive; G2. Single Bond Universal Adhesive; G3. composite primer; G4. PQ1; G5. Silane + PQ1; G6. Clearfil Universal Bond; G7. All-Bond Universal. Shear bond strength was measured using a universal testing machine (1 mm/min), and failure modes were microscopically classified. FEA was conducted under static and fatigue conditions using 3D models built in Fusion-360. Mechanical properties were obtained from technical data and the literature. A 300 N load was applied and contact detection (0.05 mm) and constraint zones were defined. Statistical analysis was performed using one-way ANOVA and Tukey’s HSD (p = 0.05). Pearson’s correlation was used to assess the relationship between bond strength and von Mises stress. The highest bond strength was found in G2 (21.54 MPa) while G1 showed the lowest (8.86 MPa). Silane-treated groups exhibited favorable stress distribution and a strong correlation between experimental and simulated outcomes. Silane applications significantly enhance composite repair performance.
This study evaluated the effects of two different restorative assemblies and restorative material type on the fracture resistance of indirect composite restorations in simulated revitalized immature maxillary central incisors. Forty-eight extracted maxillary central incisors were randomly assigned to four groups (n = 12): breCAM.HIPC endocrowns, Gradia Plus endocrowns, breCAM.HIPC crowns, and Gradia Plus crowns. Following a standardized revitalization protocol, restorations were performed and specimens were thermocycled. Fracture resistance was assessed under oblique compressive loading, and fracture patterns were recorded. Data were analyzed using two-way ANOVA and Fisher’s exact test (α = 0.05). The tested restorative assembly significantly influenced fracture resistance (p < 0.05), whereas material type did not (p > 0.05). Endocrown restorations exhibited higher fracture resistance than crown restorations regardless of material. No statistically significant material-related differences were detected within the same restorative assembly. Crown restorations showed a higher incidence of coronal fractures. These findings indicate that, under the experimental conditions of this in vitro study, the tested endocrown restorations demonstrated higher fracture resistance than the Trinia core-supported crown restorations. However, because the two groups differed not only in restoration design but also in their internal structural configuration, including the use of fiber-reinforced composite cores only in the crown groups, the findings should be interpreted as reflecting the performance of the tested restorative assemblies rather than the isolated effect of restoration design.