Schematic representation of the concept of present study. The flowchart shows the process of surface-modification of Ti ₃ C ₂ MXene and the subsequent ecotoxicological analyses employed.

A study of Ti₃Al_1−xSi_xC₂ (x = 0 to x = 1) MAX-phase alloys is reported. The materials were obtained from mixtures of Ti₃AlC₂ and Ti₃SiC₂ powders with hot pressing sintering technique. They were characterised with X-ray diffraction, heat capacity, electrical resistivity, and magnetoresistance measurements. The results show a good quality crystal structure and metallic properties with high residual resistivity. The resistivity weakly varies with Si doping and shows a small, positive magnetoresistance effect. The magnetoresistance exhibits a quadratic dependence on the magnetic field, which indicates a dominant contribution from open electronic orbits. The Debye temperatures and Sommerfeld coefficient values derived from specific heat data show slight variations with Si content, with decreasing tendency for the former and an increase for the latter. Experimental results were supported by band structure calculations whose results are consistent with the experiment concerning specific heat, resistivity, and magnetoresistance measurements. In particular, they reveal that of the s-electrons at the Fermi level, those of Al and Si have prevailing density of states and, thus predominantly contribute to the metallic conductivity. This also shows that the high residual resistivity of the materials studied is an intrinsic effect, not due to defects of the crystal structure.

For SHS of Ti3SiC2-based materials in the Ti–Si–C system, we explored the impact of silicon excess on the composition of resultant MAX-phase ma

ZrB₂-HfB₂ composites allow us to obtain materials characterized by the high chemical resistance characteristic of HfB₂ while reducing density and improving sinterability due to the presence of ZrB₂. Since boride composites are difficult-to-sinter materials. One way to achieve high density during sintering is to add phases that activate mass transport processes and, after sintering, remain as composite components that do not degrade and even improve some properties of the borides. The following paper is a comprehensive review of the effects of various and the most commonly used sintering aids, i.e., SiC, B₄C, WC, MoSi₂, and CrSi₂, on the thermo-chemical properties of the ZrB₂-HfB₂ composites. High-density composites with a complex phase composition dominated by (Zr,Hf)B₂ solid solutions were obtained using a hot pressing method. The tests showed differences in the properties of the composites due to the type of sintering additives used. From the point of view of the thermo-chemical properties, the best additive was silicon carbide. The composites containing SiC, when compared to the initial, pure borides, were characterized by high thermal conductivity λ (80–150 W/m·K at 20–1000 °C), a significantly reduced thermal expansion coefficient (CTE ~6.20 × 10⁻⁶ 1/K at 20–1000 °C), and considerably improved oxidation resistance (up to 1400 °C).