The purpose of this study is to generate some experimental data associated with the thermal heat exchange between an oil jet flow and a rotating gear. To this end, a specific test bench was designed. The principle of this test bench is to inject oil heated to a temperature of about 80 °C onto a rotating test sample at ambient temperature. Temperature measurements of the oil via injection nozzles and the rotating component allow the determination of the heat flow between these elements using a numerical method developed to this end. This test rig enables the study of the parameters that may affect heat exchange, such as oil flow rate and injection temperature, nozzle geometry and position, gear rotational speed and tooth geometry, or oil characteristics. In this study, three of these parameters were investigated, namely the test sample rotational speed, the oil flow rate, and the oil jet velocity. The experiments were conducted on an aluminum disc and spur gear. Subsequently, the experimental results were compared with existing models that represent the convective exchanges between oil and a gear. Some discrepancies between existing models and experimental results appear at high rotational speeds, underlining that the convective heat transfer does not always increase with this parameter.
A quasi-static chain drive model is proposed. This model, consistent with single speed cycling application, applies to simple two sprocket drives. The kinematics of the transmission is determined, including the capture and release positions of the rollers and the influence of the polygonal effect. The tensions into the links and the contact forces (between rollers and sprocket) are then calculated based on the results of the kinematic analysis. Both chain strands are assumed to be straight and their tension are considered as imposed. An estimate of the roller displacement is proposed using existing studies on the relationship between loading conditions and roller positions along the sprocket tooth profile. The presented model, is then used to assess the contribution of both meshing and roller motion on the global efficiency of the drive. Calculations show that the magnitude of both loss sources is similar for a wide range of gear ratios and loading conditions. According to the presented results, the relative motion between the rollers and the sprocket tooth profile should be considered in future studies dedicated to chain drive efficiency.
The objective of this paper is to analyse the effect of thin-webbed/-rimmed and consequently flexible gear bodies on dynamic tooth loads. To this end, an approximate dynamic factor formula is used, which makes it possible to estimate dynamic mesh force amplifications from Finite Element models, strain energies and quasi-static transmission errors. It is shown that, whenever solid gears are considered, the dynamic factor derived from the complete FE model results agrees well with those given by the analytical formula. When thin-rimmed/webbed gears are considered, the outcomes from the approximate dynamic factor formula are still in reasonable agreement with those of the complete FE model although the influence of rotating gear body cannot be accounted for. This good agreement also reveals that, for the tested geometries, dynamic couplings between dynamic mesh forces and gear body elasticity remain moderate.