Churning losses are a complex phenomenon which generates significant power losses when considering splash lubrication of gear units. However, only few works deal with bevel gears dipped lubrication losses. The objective of this study is to provide a wide variety of experimental tests on churning losses, especially getting interested in geometry of spiral bevel gears influence. A specific test rig was used in order to study a single spiral bevel gear partially immersed in an oil bath. Experiments have been conducted for several operating conditions in terms of speeds, lubricants, temperatures and gear geometries to study their impact on splash lubrication power losses. These experimental results are compared with the predictions from various literature sources. As the results did not agree well with the predictions for all operating conditions, an extended equation derived from previous works is introduced to estimate churning losses of bevel gears.
In order to use electric motors which run up to 40,000 rpm in future automotive applications, this study aims to experimentally investigate if splash lubrication technique is worth considering for high-speed gears, i.e., for tangential gear speed up to 60 m/s. To this end, a specific test rig has been used to operate a single spur or helical gear in various operating conditions (lubricant, oil sump volume, temperature, etc.). Churning loss is measured and, as the fraction of air in the lubricant (namely, oil aeration) can be influential on this source of dissipation, a specific sensor is also employed for online monitoring of oil sump aeration. By inserting some moveable walls in the gearbox, it is demonstrated that churning losses and oil aeration can be significantly reduced by mounting these flanges at an appropriate distance to the gear lateral faces. Based on dimensional analysis, an engineering criterion is proposed to properly choose the clearance between the tested gear and the flanges.
Oil sump lubrication is commonly used in gearboxes. When considering consistent speeds, oil immersion is usually set to low level in order to reduce associated power losses. This configuration is already used in some parts of helicopter mechanical transmissions, and it is under consideration as a lubrication solution for future electric powertrain where gearbox input speeds may be very high. The gear drag power losses are generally evaluated from either a churning power loss model for classic oil sump lubrication or a windage power loss model for oil jet lubrication. One may thus wonder how to estimate drag losses when considering a gear that only a small part is immersed. In this study, the authors investigate the transition between churning and windage phenomena for a spur gear. A series of torque measurements on a single spur gear rotating in an oil bath at numerous oil immersion levels have been carried out. Based on these results, a criterion to indicate which power loss model to use is proposed.
The purpose of this study is to generate some experimental data associated with the thermal heat exchange between an oil jet flow and a rotating gear. To this end, a specific test bench was designed. The principle of this test bench is to inject oil heated to a temperature of about 80 °C onto a rotating test sample at ambient temperature. Temperature measurements of the oil via injection nozzles and the rotating component allow the determination of the heat flow between these elements using a numerical method developed to this end. This test rig enables the study of the parameters that may affect heat exchange, such as oil flow rate and injection temperature, nozzle geometry and position, gear rotational speed and tooth geometry, or oil characteristics. In this study, three of these parameters were investigated, namely the test sample rotational speed, the oil flow rate, and the oil jet velocity. The experiments were conducted on an aluminum disc and spur gear. Subsequently, the experimental results were compared with existing models that represent the convective exchanges between oil and a gear. Some discrepancies between existing models and experimental results appear at high rotational speeds, underlining that the convective heat transfer does not always increase with this parameter.