Peak-to-average-power ratio (PAPR) and power amplifier (PA) nonlinearity are significant challenges that limit the performance of orthogonal frequency division multiplexing (OFDM) systems. Various techniques have been proposed to address these two issues separately. In this letter, we propose a unified framework for PAPR reduction and digital predistortion (DPD) by optimizing the waveform of the OFDM signal. We develop two effective and low-complexity algorithms to address the joint PAPR and DPD optimization problem. Simulation results demonstrate that the proposed algorithms surpass existing approaches in terms of error vector magnitude (EVM), PAPR, and power spectral density (PSD).
14 June 2024 in IEEE Antennas and Wireless Propagation Letters
This letter presents a low-cost antenna deployment optimization method for the coverage performance improvement in high-speed railway (HSR) communications. The installation status of the base station antenna is optimized to realize the best projection of the antenna gain pattern on the line-type coverage area for the railway dedicated network. Detailed analysis of the optimized antenna deployment is conducted for different range of the engineering parameters of the sites. Moreover, a simplified deployment method is presented and verified, suitable for both the discrete antenna with a flexible azimuth angle and integrated antennas with a fixed included angle. The field test is carried out to validate the superior coverage performance of the proposed antenna deployment solution in comparison with traditional antenna solutions.
At present, the demand for accurate indoor positioning at a low cost is increasing. Based on the architecture of networking passive radio frequency identification (RFID) systems, research into passive location algorithms is important for finding a location solution with ultra-low cost, easy implementation, and no required maintenance. In this paper, TDACC (time difference of arrival with conic curves) based on signal propagation time is proposed, which breaks down the positioning problem into solving the intersection of an ellipse and a hyperbola. The results indicate that this method has a positioning error of 0 m in the absence of signal interference. When the time delay fluctuates to 1 ns and 2 ns, the average errors of TDACC are 0.19 m and 0.33 m, respectively. Different from other time-based localization methods, the proposed method only requires two distribution nodes without time synchronization, which reduces the system cost. These results will help to promote the deeper semantic communication level fusion of passive RFID. By improving the coordinate positioning in the semantic prior knowledge base, this method will lead to more efficient and accurate industry applications.
30 January 2025 in IEEE Internet of Things Journal
Multiple-input multiple-output (MIMO) optical wireless communication (OWC) is a promising technology capable of providing high data rates. However, inter-user interference can negatively impact system performance. Existing studies employ CVX-based beamforming designs to mitigate this issue, but these approaches suffer from high computational complexity. To tackle this challenge, this paper studies the low-complexity beamforming design to maximize the sum rate. Specifically, we first utilize the fractional programming (FP) method to decompose the original beamforming problem into a series of convex subproblems and propose a block coordinate descent (BCD)-based beamforming framework. Then, we provide closed-form or semi-closed-form solutions for these subproblems. For the general approximate sum rate maximization, we drive the optimal semi-closed-form beamforming structure based on the Karush-Kuhn-Tucker (KKT) conditions. Furthermore, we propose a closed-form solution for the upper bound maximization by taking advantage of the separability of optical power constraints. Finally, numerical results indicate that the proposed beamforming designs reduce the computational complexity significantly while keeping the sum rate performance.
During walking, the human lower limbs primarily support the body and drive forward motion, while the arms exhibit greater variability and flexibility without bearing such loads. In gait-based target recognition, collecting exhaustive arm-motion data for training is challenging, and unseen arm movements during testing may degrade the performance. This paper investigates the impact of arm movements on radar-based gait recognition and proposes a gait recognition method using extracted lower limb motion data to mitigate interference from different arm motions. Gait data is collected via a millimeter-wave radar sensor encompassing four kinds of common arm movements, including natural arm swings, object-holding states, and irregular arm motions, from 11 volunteers. Using extracted lower limb motion data, millimeter wave point-cloud gait datasets covering diverse arm motions are generated. Three gait recognition experiments are conducted for comparing the performances of our proposed method using only lower limb data and existing method using all limb data, both based the on PointNet++ model. And the experimental results show that our method consistently outperforms existing methods, with a 22.9-percent improvement in accuracy. Results also show that the proposed method can enhance feature extraction, accelerate convergence, and achieve higher accuracy, especially with limited samples, and the highest recognition accuracy reaches 96.9%. In addition, in unseen arm movement cases, our method significantly outperforms existing methods, demonstrating superior robustness and recognition accuracy.
20 August 2025 in IEEE Transactions on Communications
This paper presents a new multiple-input multiple-output (MIMO) communication system. The system, termed as “pseudo MIMO”, facilitates the transmission of more parallel data streams than the number of receiving radio frequency (RF) chains. The key principle involves connecting multiple antenna elements to each receiving RF chain and employing multiple analog combining patterns for signal reception within the orthogonal frequency division multiplexing (OFDM) sampling period. Through detailing the entire transmission and signal processing procedures by matrix manipulation, the equivalent channel matrix for each OFDM subcarrier is derived in a unified matrix form, which can be further represented by the product of the analog combining matrix and the frequency domain wireless channel matrix. As per the equivalent channel matrix, an optimization problem is formulated and solved to maximize the spectral efficiency by jointly designing the digital precoding and analog combining matrices. Numerical results demonstrate that the performance of a pseudo MIMO system can closely approach that of a fully digital (FD) MIMO system with the same antenna configuration but more RF chains. It is also revealed that a low-precision discrete analog combining scheme is sufficient to achieve nearly optimal performance. Further, the effectiveness of pseudo MIMO technology is validated through prototype testing.