Bone defects remain a significant clinical challenge, creating a severe need for advanced biomaterials for tissue regeneration. This study addresses this issue by developing 3D-printed composite hydrogels containing alginate, gelatine, and resorbable calcium phosphates (monetite and brushite) for bone tissue engineering. The scaffolds were fabricated using extrusion-based 3D printing and evaluated for their morphology, porosity, mechanical strength, swelling, degradation, and in vitro mineralization, while their cytocompatibility was assessed using LIVE/DEAD cell viability assays. The key findings demonstrate that calcium phosphate incorporation enhanced the mechanical stability by 15–25% compared to the controls, and mineral deposition increased significantly in the composite scaffolds. The developed hydrogels are bioactive and represent promising, customizable scaffolds for bone regeneration. These results support their further investigation as viable alternatives to traditional bone grafts for clinical bone tissue engineering applications.
Bone defects remain a significant clinical challenge, creating a severe need for advanced biomaterials for tissue regeneration. This study addresses this need by developing and characterizing 3D-printed composite hydrogels composed of alginate, gelatin, and resorbable calcium phosphates (monetite and brushite) for bone tissue engineering. A series of scaffolds was fabricated using extrusion-based 3D printing and systematically evaluated for morphology, porosity, mechanical strength, swelling, degradation, and in vitro mineralization. The inclusion of calcium phosphates enhanced the mechanical stability and promoted mineral deposition within the hydrogel matrix, while cytocompatibility was assessed using LIVE/DEAD cell viability assays. These findings indicate that the developed 3D-printed hydrogels are bioactive, constituting promising, customizable scaffolds suitable for bone regeneration, offering a viable alternative to traditional bone grafts. The results support further investigation of these materials for clinical applications in bone tissue engineering.
The paper is concerned with experimental investigations and numerical simulations of airflow in a rigid model of human tracheal bifurcation during a respiratory cycle in the presence of cough. The main goal of the study is to calculate the velocity and tracheal wall shear stress (WSS) distributions under the time variation in the pressure difference. A sequence of inspiration-expiration of measured flow rates and pressure is used to calibrate the 3D unsteady numerical solutions for different imposed boundary conditions at the edges of the bifurcation. The experimental data are obtained using commercial medical devices: (i) a spirometer and (ii) a mechanical ventilator, respectively. CT images of the lung airways were used to reconstruct the tracheal test geometry by 3D printing techniques. Flow spectrum, vortical structures, and the wall stresses are analyzed for the computed cases. Four turbulence models (k − ɛ, k − ω SST, k − ɛ R, and LES) are compared, and all indicate an increase in peak WSS and vortex intensity during coughing versus normal expiration. The present work confirms the importance of CFD simulations to model and quantify airflow throughout the respiratory cycle. The paper proposes a method to calculate wall shear stress, one of the most relevant parameters for characterizing airway function and the mechanical response of tracheal endothelial cells.