Selecting appropriate materials is crucial for mitigating the severe economic and safety challenges posed by microbiologically induced corrosion (MIC) in marine and industrial settings. This study focuses on the MIC behavior of 316L austenitic stainless steel and 2205 duplex stainless steel that is caused by the metabolic activities of D. vulgaris during a life span of 7 days. Cell counts, weight loss, electrochemical measurements, and surface characterization were employed to evaluate the materials’ resistance to MIC. Specifically, 2205 DSS exhibited a 60% lower weight loss (0.02 vs. 0.05 mg/cm²), a 42% lower maximum pit depth (2.11 vs. 3.64 μm), and an orders-of-magnitude lower corrosion current density (0.094 vs. 2.0 μA cm⁻²) compared to 316L SS, demonstrating its superior resistance to D. vulgaris MIC. XRD and XPS analyses revealed that although FeS formed on both materials, FeS₂—a thermodynamically stable deep-sulfidation product—was only present on 316L, indicating a more advanced corrosion stage. The absence of FeS₂ on 2205 suggests limited sulfide corrosion progression. These findings confirm the advantage of duplex stainless steel in mitigating D. vulgaris-induced corrosion and provide insights into the selection of materials for MIC-prone environments.

An AA6061-7075 composite with a heterogeneous structure was fabricated via the additive friction stir deposition (AFSD) method, and in situ processing data were monitored during the manufacturing process. The results show that the cross-section of the composite subjected to AFSD exhibits a lower degree of plastic deformation behavior compared to the surface and side of the composite, owing to serious heat accumulation during the layer-by-layer stacking process. The denser, heterogeneous structure, consisting of finer (softer) and coarser (harder) grains, which correspond to AA6061 and AA7075, was formed according to transmission electron microscopy (TEM) analysis. Furthermore, the obtained composite subjected to AFSD in this work presents outstanding mechanical properties compared to other as-fabricated AA6061/AA7075 depositions acquired by other additive manufacturing methods along the horizontal building direction, with the ultimate tensile strength (266 MPa) being 89% of that of AA6061-T6 and the elongation 1.1 times that of AA7075-T6. The findings provide useful guidelines for the in situ preparation of Al-based composites and offer ideas for manufacturing high-strength heterostructures for large-scale practical engineering applications.

In this study, low-alloy structural steels with different La and Ce contents were prepared via vacuum smelting and controlled rolling and controlled cooling technologies, and their microstructures were characterized. The influence of La and Ce on the corrosion resistance of low-alloy steels was compared through indoor cyclic-immersion accelerated tests simulating tropical marine atmospheres. The corrosion mechanism of low-alloy steels with different La and Ce contents in simulated tropical marine atmospheres was investigated using electrochemical measurements and corrosion product analysis. The results show that La and Ce improve the uniform corrosion resistance of low-alloy steels. With increasing La/Ce content, the corrosion current density decreased from 1.8936 × 10⁻⁶ A cm⁻² for 0LaCe to 1.29 × 10⁻⁶ A cm⁻² for 0.3LaCe, corresponding to a reduction of approximately 31.9%. This is attributed to the fact that La/Ce addition promotes rust layer stabilization and densification, as suggested by the evolution of major rust phases and the presence of La/Ce-related oxidized species. Meanwhile, alloying with La and Ce improves the cracking of the rust layer, reduces the number of pores, and stabilizes the rust layer structure.

Cr–Cu modified steel mitigates microbiologically influenced corrosion by increasing the Cr content and decreasing the Cu content from both EET-MIC and M-MIC perspectives.