The number of large energy storage units installed in the power system has increased over the last few years. This fact remains closely linked to the increase in the share of renewable energy in electricity generation. This is necessary to maintain the stability of the grid, which is becoming increasingly difficult to maintain due to the growing number of renewable energy sources (RES). Energy production from these sources is difficult to estimate, and possible unplanned shortages and surpluses in production are the cause of voltage and frequency fluctuations, which is an undesirable state. Consequently, the use of energy storage not only contributes to the regulation of grid operation but can also, under appropriate conditions, constitute an additional load if too much energy is generated by RES, or the source when the generation from RES is insufficient. The main contributions of this paper are as follows: A presentation of practical results achieved by implementing two optimal control strategies for a 1 MW (0.5 MWh) battery energy storage (BES) cooperating with a large 144 MW photovoltaic farm. In the first case, the BES was used to generate curtailment at photovoltaic farm to avoid power grid overload. The second case focuses on maximizing profits from selling the energy produced in periods when the unit price for energy was the highest according to energy market forecasts. In both cases, the storage was used simultaneously to cover the producer’s own demand, which eliminated the costs associated with the purchase of energy from the operator, especially during the night supply. A technical and economic evaluation was prepared for both cases, considering the real profits from the investment. The potential of using the BES to increase the functionality of photovoltaic energy sources was determined and discussed in the paper.

This paper presents aspects of modelling and simulation of energy storages based on the example of a lead-acid battery pack for powering an electric vehicle. The most frequently used energy storages, with particular emphasis on the difficulties in their proper selection for mobile equipment, was discussed. The mathematical model of the leadacid battery and the relations describing its respective parameters was also presented. A selected energy storage was subjected to detailed analysis with regards to the electrical and thermal parameters while powering an electric vehicle during an standard driving cycle in an urban area. The simulation was performed in the Matlab Simulink environment.

The development and advantages of renewable energy technologies mean that their areas of application are constantly expanding. The development of roads, transport systems, and electromobility also increases the demand for electricity. Roads occupy a certain area that could be used to install wind turbines or photovoltaic systems that could be used to power, among others, electric vehicle charging stations and road technical infrastructure facilities (travel service areas, tunnel lighting, road signs). There are many examples around the world where such solutions have been used. This critical review of existing solutions and the possibilities of their application in new places may contribute to further development and research in this area. Particular attention was paid to the possibility of using renewable energy systems in Poland, which can be successfully transferred to other countries with a similar climate.