Molecularly imprinted polymers (MIPs) are widely employed for selective adsorption of target molecules in sensing and separation applications. The architecture of MIP films can influence adsorption behavior, interfacial stability, and reusability, yet systematic investigations of these effects are limited. This study aimed to evaluate how different polypyrrole (PPy) MIP film architectures affect the adsorption, stability, and regeneration characteristics of geraniol-imprinted layers on gold electrodes. Geraniol-imprinted and non-imprinted PPy films were electropolymerized onto quartz crystal microbalance (QCM) substrates. Two film architectures were compared: (i) a single-layer geraniol-imprinted PPy film, and (ii) a double-layer film consisting of a non-imprinted PPy underlayer followed by a geraniol-imprinted layer. Film characterization was performed using cyclic voltammetry (CV) and electrochemical quartz crystal microbalance (EQCM) measurements. Adsorption–desorption cycles were conducted to assess mass uptake, signal stability, and regeneration performance. EQCM analysis revealed that the double-layer architecture exhibited enhanced frequency signal stability during repeated adsorption–desorption cycles compared to single-layer films, suggesting a stabilizing effect of the underlying non-imprinted PPy layer at the electrode interface. Geraniol-imprinted films demonstrated significantly higher mass uptake than non-imprinted controls, confirming the sensitivity provided by molecular imprinting. Single-layer films showed more variability in signal response and less consistent regeneration performance. The architecture of MIP films significantly affects adsorption behavior, stability, and regeneration on electrode surfaces. Incorporating a non-imprinted PPy underlayer can improve signal reproducibility and enhance the robustness of MIP-based sensing interfaces. These findings provide guidance for the rational design of MIP coatings for electrochemical sensors and QCM-active platforms.
To develop molecularly imprinted polymer (MIP)-based biosensors effectively, it is necessary to evaluate the potential adsorption of materials onto the electrode surface. Therefore, we investigated the adsorption of geraniol and pyrrole and compared them. In addition to determining adsorption constants, particular focus was placed on adsorption mechanisms, as they directly influence monolayer or multilayer formation, template removal efficiency, and the selectivity of the final imprinted structure. To achieve this, we employed various electrochemical methods, including cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), and quartz crystal microbalance (QCM) measurements. Measurements were repeated to ensure reliability. The findings were used to calculate adsorption constants using the Langmuir equation. Geraniol and pyrrole showed adsorption constants of 21.5 L/mol and 31.7 L/mol, respectively, indicating strong molecular interactions. These results indicate strong interactions between the two molecules, suggesting that geraniol influences electrode polymerization. This led to the importance of proper surface preparation, evaluation of analyte–monomer interactions, and the opportunity to reuse materials.