In this paper, small-scale testing techniques—nanoindentation and micropillar compression—were used to investigate the deformation mechanisms, size effects, and strain rate sensitivity of (100) and (110) single-crystal Gum Metal at the micro/nanoscale. It was observed that the (100) orientation exhibits a significant size effect, resulting in hardness values ranging from 1 to 5 GPa. Conversely, for the (110) orientation, this effect was weaker. Furthermore, the yield strength obtained from the micropillar compression tests was approximately 740 MPa for the (100) orientation and 650 MPa for the (110) orientation. The observed deformations were consistent with the established features of the deformation behavior of body-centered cubic (bcc) alloys: significant strain rate sensitivity with no depth dependence, pile-up patterns comparable to those reported in the literature, and shear along the {112} slip directions. However, the investigated material also exhibited Gum Metal-like high ductility, a relatively low modulus of elasticity, and high yield strength, which distinguishes it from classic bcc alloys.
Niobium nitride (δ-NbN) coatings were deposited on AISI 316L austenitic steel using reactive DC magnetron sputtering. This study investigates the effects of air oxidation on the surface morphology, topography, roughness, nanohardness, adhesion, and wear resistance of NbN coatings. Their microstructure and thickness were analyzed by scanning electron microscopy (SEM), while surface morphology and roughness were assessed using atomic force microscopy (AFM), and surface topography was assessed by an optical profilometer. Nanohardness was measured using a Berkovich indenter. Adhesion was evaluated via progressive-load scratch testing and Rockwell indentation (VDI 3198 standard). Wear resistance was assessed using the “ball-on-disk” method. Both as-deposited and oxidized NbN coatings improved the mechanical performance of the substrate surface. Air oxidation led to the formation of an orthorhombic Nb2O5 surface layer, which increased surface roughness and reduced hardness. However, the brittle oxide also contributed to a lower coefficient of friction. Despite reduced adhesion and increased surface development, the oxidized coating exhibited a significantly lower wear rate than the uncoated steel, though several times higher than that of the non-oxidized NbN. Considering its good wear and corrosion performance, along with the bioactivity confirmed in earlier research, the oxidized NbN coating can be considered a promising candidate for biomedical applications.
Developing thick and well-adhered high-entropy alloy (HEA) coatings remains a major technological challenge due to the high cost and complexity of existing deposition methods. This study introduces a novel hybrid approach that combines mechanical alloying, electrochemical co-deposition, and high-temperature annealing to fabricate CoCrFeMnNi-based coatings. In this process, HEA powders obtained by mechanical alloying are suspended in a classical Watts bath and co-electrodeposited with nickel onto copper and steel substrates. Subsequent annealing promotes homogenization and diffusion between the coating and substrate, producing dense layers up to 100 μm thick. Structural and chemical analyses revealed face-centered cubic solid solutions with excellent adhesion and a maximum hardness of 6.25 GPa. The use of co-electrodeposition enables easy incorporation of complex HEA compositions using conventional electrochemical equipment, drastically reducing the cost and process temperature compared with vapor- or laser-based methods. The developed technology not only overcomes the limitations of direct HEA electrodeposition but also allows the deposition of coatings on complex geometries using environmentally friendly aqueous electrolytes. This simple yet versatile approach opens new pathways for producing high-performance protective coatings for applications in energy, aerospace, and nuclear industries, where mechanical robustness and chemical stability at elevated temperatures are critical.