Condition assessment of works of art created with oil media on paper could be a complex matter when presenting problems of damage due to the absorption of oil binders by the paper support, since they depend on several factors and occur in variable conditions. The present work refers to the results of an investigation on the effect of linseed oils on the color, opacity, morphology, tensile strength, and chemical properties of lignocellulosic papers, in comparison to that of pure cellulosic papers. Lignocellulosic papers are involved in research on new, yet significant, parameters that might influence the behavior of the oil-impregnated areas of the supports upon aging. The research was applied to mock-ups, made of two types of lignocellulosic paper impregnated with three types of linseed oil and subjected to accelaratated ageing in specific conditions of relative humidity and temperature in closed environment. The research involved colorimetry, opacity, tensile strength, pH measurements, SEM, FTIR, and VOC analysis with GC-MS. The results indicated that thermal-humid ageing caused the gradual darkening of the oil-impregnated mock-ups, alterations in opacity, and decrease of pH values, depending mainly on the formulation of linseed oil, as well as a reduction in tensile strength. FTIR analysis results indicated that the chemical changes that occur upon ageing supported the recorded optical and mechanical alterations, while VOC emissions are both associated with the paper type and the kinetics of degradation of the different types of linseed oil.

Oil media on paper, such as oil paintings, sketches, prints, and books, occasionally present problems associated with the effect of oil medium on the paper support, raising a composite matter of condition assessment as it depends on several factors. The present work examines the effect of linseed oil on paper and, in particular, the changes caused by three types of linseed oil on the optical, morphological, mechanical, and chemical properties of pure cellulosic paper, employing mock-ups submitted to artificial ageing in controlled conditions of relative humidity and temperature in airtight vessels. The study involved colorimetry, opacity, tensile strength, pH measurements, SEM, FTIR, and VOC analysis with GC-MS. Processing of the results has so far indicated that thermal-humid ageing caused the gradual darkening of the oil-impregnated mock-ups, as well as alterations in opacity, intense fall of pH values, and severe reductions in tensile strength, while linseed oil processing during manufacture has a significant impact. FTIR spectra have indicated that chemical changes upon ageing are in accordance with those of optical and mechanical changes, while VOC emissions are mostly associated with the drying and degradation of the different types of linseed oil.

The structural properties of phosphor materials, such as their grain size distribution (GSD), affect their overall optical emission performance. In the widely used gadolinium oxysulfide (Gd₂O₂S) host material, the type of activator is one significant parameter that also changes the GSD of the powder phosphor. For this reason, in this study, different phosphors samples of Gd₂O₂S:Tb, Gd₂O₂S:Eu, and Gd₂O₂S:Pr,Ce,F, were analyzed, their GSDs were experimentally determined using the scanning electron microscopy (SEM) technique, and thereafter, their optical emission profiles were investigated using the LIGHTAWE Monte Carlo simulation package. Two sets of GSDs were examined corresponding to approximately equal mean particle size, such as: (i) 1.232 μm, 1.769 μm and 1.784 μm, and (ii) 2.377 μm, 3.644 μm and 3.677 μm, for Tb, Eu and Pr,Ce,F, respectively. The results showed that light absorption was almost similar, for instance, 25.45% and 8.17% for both cases of Eu dopant utilizing a thin layer (100 μm), however, given a thicker layer (200 μm), the difference was more obvious, 22.82%. On the other hand, a high amount of light loss within the phosphor affects the laterally directed light quanta, which lead to sharper distributions and therefore to higher resolution properties of the samples.