This study delves into selective laser melting (SLM). By using M300 steel in virgin and recycled powder form (after 20 cycles), with the aim of reducing the cost of printing for the practical application of M300 maraging steel, a comprehensive comparison between the two types of powder was evaluated. The powder’s morphology was analyzed using scanning electron microscopy (SEM) and backscattered electrons (BSE). The particles were seen to have a spherical shape, with a notable number of satellites attached to their surfaces. The particle size distribution (PSD) was examined and ranged from 10 to 90 µm for both powders. In addition, the porosity exhibited an average value of 0.07% for the virgin powder and 0.10% for the recycled powder. The microstructure was examined. Additionally, the surface wettability was tested, and it was seen to display wetting behavior for both types of powder, while blackened surfaces showed a higher wetting angle than untreated surfaces (hydrophobic). The 2D roughness measurements showed that the recycled powder had no significant difference from the virgin powder (Ra = 5.33 µm, Rz = 24.17 µm) before blackening and (Ra = 5.48 µm, Rz = 24.07 µm) after blackening. Corrosion tests proved that the recycled powder did not affect the corrosion properties of the material, while blackening caused partial surface corrosion in both types of samples, regardless of the used powder.

Workshop organized by INDIGO project as a collaborative activity among EU funded projects in the area of District Heating and Cooling. The objective of the workshop was twofold: (1) to create a cluster of European funded projects working in the area of District Energy Systems; and (2) to create a networking opportunity in which to share experiences on the results and difficulties of the researches, and to identify synergies.

Polycrystalline diamond (PCD) materials have a variety of applications, mainly as cutting tools for machining non-ferrous metals and non-metallic materials. A significant application of PCD is in oil and gas industry for rock drilling operations. Other important areas, such as mining, have yet to reach their full potential. These cutters/tools are subjected to high operating temperatures, impact loads and abrasive wear during these operations, which may lead to their sudden failure. An advantage of these materials is that their structure and composition can be engineered to return properties required for specific applications and operations.

This paper presents the development and experimental verification of a generative CAD/FEM model of an external bone fixation device. The generative CAD model is based on the development of a parameterized skeleton algorithm and...