Although hemp seed (HS) oil is characterized by more than 80% polyunsaturated fatty acids (PUFAs), a very high ω-6-to-ω-3 ratio is not a popular commodity. The aim of this work was to provide useful data about the bioactive components and cannabidiolic acid content in thirteen different commercial hemp seed oils. The investigated HS oils showed a good ω-6/ω-3 ratio, ranging from 1.71 to 2.27, massively differed in their chlorophylls (0.041–2.64 µg/g) and carotenoids contents (0.29–1.73 µg/g), as well as in total phenols (22.1–160.8 mg Gallic Acid Equivalents (GAE)/g) and tocopherols (3.47–13.25 mg/100 g). Since the high content of PUFAs in HS oils, photo-oxidative stability was investigated by determining the Thiobarbituric Acid Reactive Substances (TBARS) assay and extinction coefficient K232 and K270 after the photo-oxidative test. The percentage of increase in K232 and K270 ranged from 1.2 to 8.5% and from 3.7 to 26.0%, respectively, indicating good oxidative stability, but TBARS showed a 1.5- to 2.5-fold increase in oxidative behavior when compared to the initial values. Therefore, the diversity in bioactive compounds in HS oils, and their high nutritional value, suggest the need for a disciplinary booklet that well defines agronomic and post-harvest management conditions for achieving a good food objective.

The sol–gel route represents a valuable technique to obtain functional materials, in which organic and inorganic members are closely connected. Herein, four hybrid materials, containing caffeic acid entrapped in a silica matrix at 5, 10, 15, and 20 wt.%, were synthesized and characterized through Fourier-Transform Infrared (FT-IR) and Ultraviolet-Visible (UV–Vis) spectroscopy. FT-IR analysis was also performed to evaluate the ability to induce the hydroxyapatite nucleation. Despite some structural changes occurring on the phenol molecular skeleton, hybrid materials showed scavenging properties vs. 2,2-diphenyl-1-picrylhydrazyl (DPPH) radical and 2,2′-azinobis-(3-ethylbenzothiazolin-6-sulfonic acid) radical cation (ABTS•⁺), which was dependent on the tested dose and on the caffeic acid wt.%. The SiO₂/caffeic acid materials are proposed as valuable antibacterial agents against Escherichia coli and Enterococcus faecalis.

Cannabidiolic acid (CBDA) is the main phytocannabinoid in fiber and seed-oil hemp (Cannabis sativa L.) plants, but its potential health-related capabilities have been masked for years by a greater scientific interest towards its neutral derivative cannabidiol (CBD). This review aims to collect from the literature and critically discuss all the information about this molecule, starting from its biosynthesis, and focusing on its bioactivity, as an anti-inflammatory, anti-emetic, anti-convulsant, and anti-cancerogenic drug. Furthermore, in the awareness that, despite its multiple bioactive effects, currently poor efforts have been made to achieve its reliable purification, herein, we propose a relatively simple, fast, and inexpensive procedure for its recovery from pollen of industrial hemp cultivars. Spectroscopic and spectrometric techniques allowed us to unequivocally identify pure isolated CBDA and to distinguish it from the constitutional isomer tetrahydrocannabinolic acid (THCA-A).

Food containers made from glass are separately collected from urban solid waste at 76% in most parts of Europe. The cullet glass finds its way to re-melting, while the debris is often disposed of. With this contribution, we suggest an upcycling process where glass debris is simply ground without any washing operation and added to an alkali-activated paste. Metakaolin-based geopolymer mortar added with coarsely ground glass waste as fine aggregate has been prepared via alkali activation with NaOH and Na-silicate. After 7, 14 and 28 days of room temperature curing time, the 3D geopolymer network was investigated by Fourier-transform infrared spectroscopy (FT-IR). Vibrational spectra revealed the geopolymerization occurrences, results which have been supported by both FT-IR deconvoluted spectra and thermogravimetric analysis (TGA). Finally, the antibacterial properties were investigated against both gram-negative (E. coli) and gram-positive (E. faecalis) bacterial strains. The results suggest the ability of the 28 days cured geopolymers to inhibit the growth of the gram-negative bacterium assayed.

The weak but noteworthy presence of (poly)phenols in hemp seeds has been long overshadowed by the essential polyunsaturated fatty acids and digestible proteins, considered responsible for their high nutritional benefits. Instead, lignanamides and their biosynthetic precursors, phenylamides, seem to display interesting and diverse biological activities only partially clarified in the last decades. Herein, negative mode HR-MS/MS techniques were applied to the chemical investigation of a (poly)phenol-rich fraction, obtained from hemp seeds after extraction/fractionation steps. This extract contained phenylpropanoid amides and their random oxidative coupling derivatives, lignanamides, which were the most abundant compounds and showed a high chemical diversity, deeply unraveled through high resolution tandem mass spectrometry (HR-MS/MS) tools. The effect of different doses of the lignanamides-rich extract (LnHS) on U-87 glioblastoma cell line and non-tumorigenic human fibroblasts was evaluated. Thus, cell proliferation, genomic DNA damage, colony forming and wound repair capabilities were assessed, as well as LnHS outcome on the expression levels of pro-inflammatory cytokines. LnHS significantly inhibited U-87 cancer cell proliferation, but not that of fibroblasts, and was able to reduce U-87 cell migration, inducing further DNA damage. No modification in cytokines’ expression level was found. Data acquired suggested that LnHS acted in U-87 cells by inducing the apoptosis machinery and suppressing the autophagic cell death.

Hydroxyapatite (HA) was coated onto the surface of commercially pure titanium grade 4 (a material generally used for implant application) by a dip coating method using HA sol. Hydroxyapatite sol was synthesized via sol–gel using Ca(NO₃)₂∙4H₂O and P₂O₅ as precursors. The surface of the HA coating was homogeneous, as determined by scanning electron microscopy (SEM), attenuated total reflectance Fourier transform infrared (ATR-FTIR), and X-ray diffraction (XRD), which allowed the materials to be characterized. The bioactivity of the synthesized materials and their efficiency for use as future bone implants was confirmed by observing the formation of a layer of hydroxyapatite on the surface of the samples soaked in a fluid simulating the composition of human blood plasma. To verify the biocompatibility of the obtained biomaterial, fibroblasts were grown on a glass surface and were tested for viability after 24 h. The results of the WST-8 analysis suggest that the HA systems, prepared by the sol–gel method, are most suitable for modifying the surface of titanium implants and improving their biocompatibility.