This study focuses on sulfuric acid-anodized films formed on 2A12 and 6061 aluminum alloys, in which the corrosion behavior of the oxide films under different film thicknesses, sealing methods, and defect states was investigated through neutral salt spray testing combined with surface morphology characterization and XRD analysis. The results indicate that the corrosion resistance of anodic oxide films is positively correlated with film thickness, while the anodized film on 2A12 aluminum alloy contains more cracks than that on 6061, which can readily serve as long-term corrosion initiation sites. Although the corrosion products of both alloys are identified as Al2O3 and AlO(OH), the oxide films on 6061 aluminum alloy exhibit higher compactness than those on 2A12 at all investigated thicknesses, resulting in superior resistance to neutral salt spray corrosion, and both sealing methods provide effective protection for the 6061 aluminum alloy substrate. This study provides experimental and theoretical references for the development and application of anodizing processes for aluminum alloys in chloride-containing marine environments.
A combined pretreatment strategy involving alkaline chemical polishing and silane electrodeposition was proposed for regulating the surface state of aluminum foil and the formation of etched tunnels during DC tunnel etching. Electrochemical measurements and morphological characterization were used to evaluate the effects of this pretreatment on surface electrochemical activity and etched tunnel structure. The results showed that appropriate alkaline chemical polishing facilitated the removal of rolling-induced surface relief, improved the uniformity of surface electrochemical activity, and favored the uniform deposition of the silane film. In contrast, excessive polishing generated surface pits during the polishing process, and these preformed pits subsequently promoted tunnel merging during DC tunnel etching. Under the optimal processing conditions, the combined pretreatment significantly improved the distribution uniformity and dimensional consistency of etched tunnels and suppressed tunnel merging. Under the present testing conditions, the specific capacitance increased from 0.386 to 0.509 μF cm−2, corresponding to an improvement of approximately 31.9%. This work provides an effective approach for optimizing etched tunnel structure and improving the capacitance-related performance of aluminum capacitor foil.