Langmuir isotherm is the most common adsorption model used in the prediction of gas adsorption in most shale and coal bed methane reservoirs. However, due to the underlying assumption of single temperature, it fails to model gas adsorption where temperature differential exists in the reservoir. To address this shortcoming, temperature-dependent gas adsorption models have been incorporated into material balance calculations for accurate prediction of original gas in place as well as determining both average reservoir pressure and future performance in coal/shale gas reservoirs. The material balance equation has been expressed as a straight line with both Bi-Langmuir and Exponential models used in prediction of gas adsorption rather than the Langmuir isotherm. With this methodology, several adsorption capacities can be obtained at multiple temperatures which will allow for better estimation of original gas in place and future gas production. The results from this works show that temperature-dependent gas adsorption models can be used in place of Langmuir isotherm to account for the effect of temperature variations and more accurate representation of the adsorption of gas in coal/shale gas reservoirs.
The effect of equations of state on the performance of compositional grading models to accurately predict compositional variation with depth in petroleum reservoir has been presented. Compositional grading models considered are isothermal model, zero thermal diffusion model, Haase’s thermal diffusion model, and Kempers thermal diffusion model. The performances of these models were simulated based on tuned equations of state. The simulation results were validated with experimental data and the associated error computed as percentage average absolute deviation. The results suggest that selection of suitable equations of state has a significant influence on the performances of the applied compositional grading models.
This research aims to establish design guidelines for a cantilever triple-layer piezoelectric harvester (CTLPH) with tip mass and tip excitation, operating under resonance conditions. The guideline is derived by combining constitutive equations with Euler–Bernoulli beam theory to identify the effective parameters of the CTLPH and, subsequently, the storage voltage after rectification using a germanium diode bridge. The analysis shows that excitation frequency, piezoelectric coefficients, geometrical dimensions, and the mechanical properties of the layers all significantly influence CTLPH performance. The effects of storage capacitance and excitation frequency were experimentally validated through the design, fabrication, and testing of a prototype. Furthermore, the LTC3588 energy storage module was employed to store the generated charge from resonance motion. An advanced non-contact optical method was employed to determine the bending stiffness of the CTLPH. The output power after the energy storage module was measured across a range of resistive loads at frequencies near the resonance condition (f = 65 Hz). Results demonstrate that both excitation frequency and external resistance affect the maximum harvested power. The developed CTLPH achieved an optimum output power of 46.18 ± 0.98 μW at an external resistance of 3 kΩ, which is sufficient to supply micropower sensors.